Hi,
I am trying to run nRF24L01+ in default configuration using simple ping-pong examples using RF24 Arduino library.
The problem is that while ping-pong is getting through...
Hi,
I want to send data from one peripheral(nRF51 DK) to multiple Android Phones. This will be a one way connection from the peripheral to the smartphones. I red on the...
I am working on "nRF51_SDK_8.1.0_b6ed55fnnn\examples\ble_central_and_peripheral\experimental
\app_s130_demo\pca10028\s130\arm4" project .
In this project,in which variable...
Or is there any LCD you could suggest that doesn't need that much code? Simple numeric 2rows would be enough. Want to use it with the nRF51-DK to display some measured valued...
I would like to develop my own central device to communicate with the RedBear Arduino shield. The RB device uses a from of UART communications to send data to/from Android...
I was wanting to use a nRF24L01 with a breadboard but its pin-out didn't allow it. A solution then occurred to me based on parts at hand. I wrote it up with instructions and...
Hello. Can I get a literature to the nRF51 series?
I need a full abstraction of the nRF51, like a book or other information, it's structure schematic of build-in modules...
I did proper connection of lcd to nordic board. and did proper contrast setting.
But not able to display anything on lcd.
i am using JHD162A 16x2 lcd.
www.brodie...
Hi guys what's the latest revision of "nRF51822 Bluetooth Smart Beacon Kits"? that's the beacon with the battery, the revision is written on the envelope.
I thought it...
Hello everyone,
The more I learn, the more I learn how much more I have to learn.
I am pretty new to embedded systems development. I am tasked with developing an nRF52...
Hello,
I've had to redesign my bootloader and I am now stuck with a problem that I can not solve. I need to know the correct workflow for switching from bootloader to application...
I use the nrf51822QFAA, and s110 v8.0.0.
now I need update the application,i have the keil created hex file,
How can I create the ZIP file use the application hex file?...
I have built a PCB that includes the nRF51822. I have AIN7 reading an input voltage that I measure on my DMM at 269mV.
When I measure the voltage through the nRF51822's...
Hi, I have an application where I am recording button presses using a beacon-like implementation. The button presses represent start/finish events for a race and are communicated...
In my setup, i have a Node with SD130 as peripheral to Smartphone and as a central to a BLE peripheral.
I need to store some Unique ID about the Smart phone and a Peripheral...
I find out that
The s110 can only connect to a single
central, but is able to do
non-connectable advertising while in
that connection
by here
So is this...
Hello,
I have a problem with the sd_flash_write function. It HardFaults on me and I can't seem to find out why. The Addresses are 4 byte aligned...
The function is called...
Hello,
I have written a timer driver with timer 0 without SD and used 24 bit mode and it is working.
But when I used the same driver with softdevice and Timer 2 and...
I have a problem enabling TIMER1:
If the prescaler is set between 16MHz and 2 MHz the firmware fails to enable the SoftDevice, even if I didn't manage TIMER0, but TIMER1...
Hello, I have looked into the compatibility matrix and I couldn't find any clear answer about if the NRF Beacon Kit is compatible or not with the S130.
Does anyone tried...