nRF52840 NCS 3.0.1 RCP
I just installed the NCS 3.0.1 SDK. I am trying to set up a border router on a Raspberry Pi 4.
I followed these instructions on the Raspberry Pi...
Hello,
I have a legacy project that is using nrf5 sdk v17.0.2. I need to add the BLE DFU functionality to this project based on the nRF52840. Are there any examples on...
I was doing some developement for a custom board on NCS v2.9.1 when i noticed some of the changes i was making in my prj.conf weren't being set in the application. My impression...
In my circuit I have a MOSFET which disconnects the battery. There is a GPIO pin which turns this device on and I'm using regulator-fixed to drive it during start-up. A short...
We are currently using ncs 2.9.0 on an nRF5340. We use the BT_HCI_OP_VS_READ_VERSION_INFO to determine at runtime what version of the BLE stack is present. This information...
Hi I'm trying to load a custom board with nrf9160 with the Serial LTE Modem, and route the AT commands to the UART from a coprocessor (ESP32C3) I have followed the guide on...
Hello,
we have a working system on the nrf9161 that works without zephyr. We have our own secure firmware that successfully uses the cc310 after we start the actual application...
Hello, we have a custom board based on the CEAA WLCSP reference schematic with internal LDO setup. Our supply voltage is 1.8V (VCC_nRF). Unfortunately we don't see any BLE...
Hi,
We are planning to use the SWD Tag Connector with our nRF51822 platform.
Please refer the snapshot for pin 3 connection on our board with Tag connect footprint.
Pin...
Hi
My product is ready for mass production, before start to sell, we need to do the Bluetooth qualification, we asked several local test labs, they told us that their test...
Where can we by a connector that fits into the antenna connector.
We have nRF51-DK development kit and want to connect to externa PA with an antenna connector and have trouble...
Hello Guys,
I'm implementing the ble_app_hids_mouse. I can pair with Windows, I see the mouse arrow moving around etc everything looks good except when I tell Windows to...
Hi,
I have successfully enable the app_timer module which toggle an output pin on every interrupt, and now I want to enable an interrupt on every 400us with %10 accuracy...
I want, without success, to wake-up from SYSTEM OFF state, send advertisements with some custom data and go back to sleep.
The counter value is always 0, instead of being...
Hello,
I use nrf51422 to connect the ANT device(Heart rate monitor) and it can work .
My question is ,
I want to assign a new device_number to 51422 and use this new...
Downloaded an used the latest (2 months old) code from DFU-Bootloader-for-nRF51-Evaluation-Kit
After it didn't work out the gate, I've attempted to narrow down and root...
Hi
In the new SDK 7.0.1 a new characteristic "Revision" was added to the DFU service. What is the meaning of this revision? In the bootloader library of the SDK the value...
Hi guys,
we are currently evaluating the nrf51422 chips for our product. We have ordered the N5 Starter Kit from Dynastream and were able to flash different sample projects...
Hi,
I have successfully add the characteristic user description into all of my characteristics.
I used master control panel to verify that my characteristics has characteristic...
A lot of the SoftDevice documentation I have been reading indicates that "Appendix A: SoftDevice architecture” in the nRF51 Series Reference Manual is prerequisite reading...
