Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
SoftDevice : S110 7.1
SDK 7.2
Example : experimental_ble_app_uart
Using IAR 7.1
Using nRFGo Studio 1.19.0
Board : PCA10001 V 2.0.0 (Rev. 2 MCU)
Test device...
Hi, recently I'm looking at some computer architecture books.
So my question could be easy or silly.
I tried to search more but I couldn't find many.
The nRF51822...
Since the SoftDevice uses Timer0, am I correct in assuming that the maximum number of PWM channels for nRF51-DK with SoftDevice running is 4? (Two each on Timer1 and Timer2...
Hi Expert,
At my nRF51 platform, I opened two GPIOTE users one of which is used to handle an external sensor interrupt. After invoking app_gpiote_user_register(&sensor_gpiote_user_id...
I am seeing some very strange behavior when using an ANT channel with the sd_ant_acknowledge_message_tx call to guarantee message deliveries between a master and slave.
...
hello I am using nRF51822 microcontroller and KIELuvision5 for programming, I am new to this platform kindly need your help, I was compiling the basic code it toggles an LED...
I tried to follow some tutorials on this site to build the samples for the beacon modules using gcc.
I am seeing this error:
Compiling file: bootloader_util_arm.c
...
I download my elf file using SEGGER Jlink via Eclipse. The instruction pointer gets positioned on the Reset_Handler. But when I try to run the code after that, I get a SIGTRAP...
HI:
I try use pstorage_raw_mode to store data. According to the document description,first steps:
ble_stack_init() and scheduler_init(). Then, in turn, calls the function...
Hello,
I need a FIFO buffer for at least 20 arrays with 8 int32 in each... for use in an algorithm.. is there a more elegant way than just copying them all around each...
I'm using the mbed platform and have been battling hard faults as I try to find the best way to write with high frequency to SPI to update a series of LEDs while still allowing...
I'm migrating an old (but working) app from the S110 5.2.1 (SDK 4.X) to the latest SDK9/S110 8.0. I've read the migration doc, and I'm following the examples carefully (specifically...
