After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
By default, the NRF_DEBUG is disabled. After enabling, and removing this assert check:
devzone.nordicsemi.com/.../
I am now hitting another one here:
#if ( configUSE_TICKLESS_IDLE...
Reading the documentation online for the BPROT component for the nRF52832, it seems like resetting is the way to clear the Write Protection bits in BPROT. Is resetting the...
I'd like to be able to change the ble connection interval during during runtime to save power. I followed this post and found that p_ble_evt->evt.gap_evt.params.connected...
Hi,
We like to develop a battery powered device with small current consumption which will communicate with mobile devices over BLE. It will comunicate with mobile device...
Hello Everyone,
It is unclear to me how a soft-device operates regarding multi-tasking and event-handling. I'm assuming Nordic engineers have their own real-time operating...
Hello, i wanted to ask if NRF51 Dongle NRF51-Dongle is capable of sniffing packets from NRF52xx parts? If yes, what are the limitations, because i think that nrf52xx parts...
Below linked blogpost says,
if using a PCB antenna, the matching network should consist of one shunt component.
devzone.nordicsemi.com/.../ .
And in the reference design...
Greetings,
For my application,I need to change the nrf51's mac address.
Previously I have changed the MAC id using the following code,
static ble_gap_addr_t m_central_addr;...
Hello friends,
i am new to embedded programming and trying to learn the new things in embedded for this i am doing 1 project in which i am using mpu9250 with pwm.
is...
Hi,
I want to interface FN-M16P with nRF52 through UART. To access this module I need to send commands to perform specific actions.Is there any specific example like this...
Hello,
I am new in this community and I am trying to get started with developments using nRF52840 DK. I am using SDK 13.0 for the library and I compile my code using armgcc...
I would like to be able to leave the bootloader installed and debug an application. I have been able to use the merge tools to get the hex files all merged and generate the...
Hi, i'm currently working on a low power sensor device based on nrf52832. I want to transfer data only to bonded central devices. Priority is using static passkey, but my...
After reading a few related questions and the official tutorial, I have a guess, hoping to confirm:
If I do not need to add extra events into schedular for management purposes...
