Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
I am using nrf52832 for my application. The application share same SPI module for two sensors(with sensors are selected using two chip select pins). Is it possible...
Hello ,
following are my requirements :
to create a secure bootloader which checks app validity at every boot .
the boot loader should also accept UART communication...
I have an Eddystone beacon from minewtech...i've downloaded the nRF connect app onto my android tablet and i can connect to the beacon. the problem is that it's not "taking...
On the nRF51822 Is it possible to check the battery level using the on-board AD, software connected internally, avoiding external resistor divider.
If not what is the best...
Hello,
I've been trying to migrate a project from the nrf51822 that uses s110 7.1.0 softdevice to the nrf52832 s132 1.0.0.3 alpha softdevice. I had to change some given...
How can I found out my NRF51's device Address? (with Softdevice using Random static address?)
Does Softdevice has any API for fetching my device's BLE Address?
As I...
I'm looking at the sequence diagrams for the secure bootloader, and I'm confused about the response procedure opcode for Packet Receipt Notifications (PRN). From the diagram...
Hi
for a new project I need to combine bluetooth with 2G/4G cellular communication, and augmented positioning, meaning we want to use cell tower, GPS and scanning of Wifi...
hai
i want to store a struct contains two elements . can i store it in flash using pstorage....?
if so how can i do that.........?
or
can i store a two dimensional...
I want at s132 use RT-Thread RTOS,but I see arm_startup_nrf52.s file defined Stack_Size and Heap_Size 8K, can define Heap_Size = 0? reduce the Stack_Size (such as 4K)?
so...
Hi,
I want to know that what is the different between RS232 and TTL.
I want to know that can we two RS232 to TTL converters back to back in the wire ??
Hi,
I'm using nRF52832 Software Development Kit, PCA10040, S132.
In nRFgo Studio, I erased all my SDK.
In nRFConnect, I selected serial port which SDK connected.
And...
