I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
HI,ALL！
I tried to add a RTC wakeup funtion to my ble device, so i add the code of the Nordic board example named "rtc_example" to my program.
But it turned out that my...
Hi,
I'm working on a Keyboard&Touchpad project, very similar configuration with Smart Remote 2, so I'm considering to use nRF24LU1+ as receiver's MCU. The receiver will be...
I'm confused.
in other platform, i know flash stard and end adress ,alse page size ,i can read and write data directly.
But use pstorage mode as follows :
pstorage_init...
Hello,
I want to bring some data by UUID.
I know the ble_nus_init() can set UUID and I know it was set by sd_ble_uuid_vs_add().
But this way only change the UUID while...
Hello.
I loaded Soft Device and UART example on the board. Then I connected Nordic_UART through by Bluetooth.
And I want to add a virtual COM PORT on Win10. I entered...
I want to connect the nrf52 board to my nanoPI via cables/connectors, making a serial communication,
is there an example/tutorial for that?
It's worth mentioning that...
Hi,
Newbie question... I have latest SDK v11.0 and have built the ble_app_uart example (installing the s130 softdevice and app to my nrf51822. I can then power the nrf51822...
hello,
I need to calculate the battery life of cr1632. For the calculation I need to know what is:
-Average Current consumption of device? (nrf51822 Bluetooth smart...
Hi, everybody , I want to ask I open SDK12.2.0 bootloader_secure project compilation is wrong?
But there was no uECC . h file in SDK12.2.0 .Why is this?And I want to ask...
Hi
I am trying to test the LE Ping feature between two nrf52s. I am enabling the LE Ping feature from one device via:
ble_opt_t opt = {0};
opt.gap_opt.auth_payload_timeout...
Hi,
I have faced an issue during an I2C read operation. My code stuck in the infinite loop of
while (!nrf_twim_event_check(p_twim, evt_to_wait))
{
if (nrf_twim_event_check...
