Suppose a nRF9E5 transmitter is set for continuous transmission on a channel.
A nRF9E5 receiver listening on that channel:
finds carrier and sets CD
finds address...
I will be deploying my nRF51822-powered devices into the field and the end user will not be able to have any physical access to, for example, power cycle the board. I need...
Hi,
We are using the ble_app_uart example in evaluation board to read data from some sensors and send it to the nRF UART V2.0 in Android 4.4. Every 20 ms I am trying to...
I am try this at nrf51_sdk_v6_0_0_43681\nrf51822\Board\nrf6310\s110\ble_app_hids_keyboard
Firt I connect to Android device and keep one whitelist.pp_addrs and one whitelist...
Hi,
Parameter uint8_t ble_gap_scan_params_t::filter is present in the documentation, but not implemented.
Checked for SDK 5.2.0 and 6.0.0.
devzone.nordicsemi.com...
After I get a Disconnected() event, I want to start scanning again, therefore try to call StartDeviceDiscovery() again.
IsDeviceDiscoveryOngoing was checked before.
The...
Hello there!
At this stage of the product development cycle, we would like to be able just to take simple reading from ADP536x module (to read either battery percentage...
Hey all,
For new minor revisions (1.X.0), will they eventually be supported by telecom's that are currently running with lesser versions? For instance, the current modem...
Hi,
I am using nrf52832 with icm20948 (I2C) on custom board and I am using icm20948 for angle measurement. For custom application I added some features i.e, before reading...
Hi,
We have preloaded the module test board with the DTM test from NRF5_SDK16.
The lab is requesting for the driver to pull up the testing interface and instructions...
I am exploring nRF52833 in a project using DK and Keil IDE. However, I keep getting errors when I attempt to download DeviceFamilyPack, etc. This error only occurs if I try...
Hi,I have a problem.I used three channels of ADC sampling in the project.If I connect the ADC port directly to GND,the ADC value of the sample is not equal to 0.But if I change...
hai ,
In my application , my nrf52840 device in peripheral mode to connect with central (ESP32).
then if i get a mac id from central ,i need to connect over with central...
Hello,
For my project I use uVision v.5.23.0.0; now I am willing to prepare two different targets using the same source files: one target for debug, with included the drivers...
Hi,
I am using nRF5_SDK_15.2.0_9412b96 SDK and dev board - PCA10056 V1.1.0 2019.22 - 683524107
USB serial driver is not detected on Windows 8.1 Pro while testing my customized...
Hello,
I am starting with app development for nRF Connect Desktop. I downloaded the Bluetooth Low Energy app from Nordic Github and put into .nrfconnect-apps\local. nRF...
Recently after updating to iOS 13 there seems to be an issue with the BLE indications. The iphone is unable to receive indications of value being changed. Earlier this used...
Hi, we are seeing subtle timing differences in code execution between when we have a debugger attached or not (same build of code).
Does the nRF52832 implement the optional...
We've been having an issue in the firmware for our project. The firmware will build, program, and run just fine, but if we try to run from the debugger, the debugger will...
