But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hi
So, Im trying to repeat the ble_central_and_peripheral example but with my own services. To be easier let's call the service " snsr ". So, I did the snsr.c and the snsr_c...
We have a situation where a device might have a sim card field installed, and sometimes, depending on the vendor, the APN settings might need to get changed.
Is there a...
Hi! We're using SDK 16, trying to implement OTA DFU functionality on our NRF52840 device with SD S113. Previously, SD S140 was used on our boards, and so when getting the...
Hi All,
We met a problem when we update the DTM SDK.
The conditions:
1. Same hardware
2. Use official nRF52832 Development board.
A. Old DTM SDK
SDK version...
Hi,
Due to work reasons I had to switch to KiCad. I have tried to recreate the reference design from Altium and the one for Eagle found here: https://github.com/NordicPlayground...
Hi,
Doing some power testing on the nrf9160 custom board using the MQTT example, I am seeing between 190uA to 200uA of sleep current using a meter.
I disabled serial...
Hey let’s say I use zephyr to code some Bluetooth mesh stuff on an NRF52832 module and then make a product using this module. Do you guys know if there are things I have to...
Hi! We have a peripheral which uses an 'unconventional' SPI configuration for its data transfer. Among other things, it sends and receives data on the same SPI line, meaning...
Hi,
In our design we are using 25AA320 with nRF9E5 . It seems in some random conditions the EEPROM loses data and the application won't run until EEPROM is reprogramed...
I'm looking for Advertisement receiving code with control radio module without softdevice.
I want to make extremely low power control code for advertisement.
please help...
Hi, I am a beginner, during my internship I need to evaluate the nRF9169 DK for cellular applications.
I successfully implemented the communication over serial by using...
Hi,
Recently I degubbed issues on debug mode for an application on segger embedded studio 4.1.2. Now I see in release mode some kind of errors is happening, it works well...
Hi,
I'm using NRF_WDT and it works very good.
I would like to investigate my project failures and I want to save some data when watchdog is expired.
How can I catch...
I am newbie here. I was reading ‘Introduction to Nordic nRF5 SDK and Softdevice' dated 15 Jan 20. The softdevice naming rule establishes Sxyz
wherein z – denotes the SoC...
Hi,
We're noticing high power consumption when the 9160 is supposed to be PSM sleeping in borderline signal locations that is breaking our power consumption model, reducing...
