I am looking for cheapest (up to few hundred USD) and simplest Arduino basic solution to track real-time RFID tags distance (also direction if possible) without additional...
Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
Hello,
We are currently trying to find our way in all the documentation and procedures required to qualify our product with the Bluetooth SIG. I am using their Launch Studio...
the interval parameter setting in application don't take effect,,, device still run with DFU-bootloader's connection interval setting.
i use nRF5_SDK_13.0.0-1.alpha.
...
Hi, everyone.
I have developed own application base on ble_app_uart.
But now I have to upgrade OOB pairing with NFC.
I have some problem.
First, I have to use...
i want to pair the device by one key. push the key ,the host pair the device. if not to push the key, the host can not pair the device.
the key is yes/no
how to set ?
Are there any library for One Wire protocol?
I found for using Arduino, but we use nRF5 DK with Segger Embedded Studio. We wil use DS18B20 standalone sensor.
I need a module that I can poll over SPI from my host MCU an output of a FIFO buffer of incoming packets (MAC address and RSSI) on channel 37 Bluetooth. Or a module where...
I would like to close a button cell battery (3V) directly to VDD and define the VDD as ADC input. I would like to measure the button cell battery voltage via the internal...
Dear Sir,
I am interfacing nRF24L01 with Renesas R5F104 Microcontroller on transmitter side and my Reciever is nRF24L01 interfaced with Arduino Uno Board.The Transitter...
I am very new to this so apologies in advance .
When I compile the sample code using Keil for the Thingy i get the error message.
.\_release_v1_0_0\app_thingy_s132...
hi, I am updating the sdk from 12.2.0 to 14.2.0, and using softdevice s132. I get a problem by connecting device using ios devices, but it works fine with android device....
Downloaded the S132 from the NRF52840 site and loaded it onto the NRF52840DK board using NRFgo studio.
Then created a new project in CrossStudio. Imported the memory map...
