Hi,
I have two nearly identical revisions of a board with an nrf5340 which behave differently in a curious way:
On one revision I can issue a "mon reset" command in...
Hey Team,
I'm trying to flash the audio application on our custom PCB, this PCB follows the interfaces of the nrf5340 audio dk. Previously on lower SDK versions (2.7-2.9...
Hi Nordic team,
This is a follow-up to my previous question here:
Can nRF52833 perform PAwR while also syncing to another PAwR device?
We are now extending our design...
Hi,
I'm trying to build nmea parser, so I have a functionc hecking all nmea sentences and trying to get double value, but I always go bad double value. For example here...
Hi
I am trying to setup and test the OpenThread CSL feature on nrf52840DK with OpenThread daemon and RCP mode nrf52840DK.
I found there is a way to build the Daemon for...
Hi,
With several nrf52840 based prototypes, I had serious problems. I could see them die after flasing them a few times. And this was not just one dying, it was all of them...
Is a common ground required when measuring current in current meter way?
Can externally supplied voltage exceed 5V? Will this cause inaccurate test results?
With nRFgo Studio, I define the services in the nRF8001: I create the pipes I need, and so on...
Is there any way to increase the number of credits (i.e. the number of...
Hi
Where do I find a measurement report from Nordic which shows the average current consumption for a typical BLE application (1 seconds advertising period e.g.)?
Until...
I a writing my own interrupt and DMA based code for sending commands and getting events from the nRF8001. The 8001 creates an event for every command, but if you want to clock...
Hi ,
i read tha the default profile for BLE is GATT but in the BLE_templete GAP is used. How can i interpret this? Which Profile i have to use when i wannt support for...
Hi!
My idea of sending a packet would be:
-regulary send a packet with fixed length (stated in static length field) to a base: i.e send the temperature =>4byte
-if...
Hi,
I use the nRF51822 on the PCA10001 and nRF6310/PCA10005 boards. I modified the radio_tx_example and wanted to read the actual state of the radio. Therefore I used a...
Hi
Could I modify HID report descriptor length over 255 bytes? In Desktop1.2.2.293, the returned descriptor size is only decided by wLength LSB byte and ignores MSB byte...
Hi,
I am trying to figure out how I can advertise with a custom UUID...
I know I have to start by adding a base address and then build on top of it. However, when I try...
I have a system that uses 5-byte addresses. The first 4 bytes are always the same, but the last byte has 4 different values. For test purpose I want to listen, from another...
Title says it all. My nordicsemi.com id/pw is not working here. (But it isn't working there either. I'm getting the following error, which I presume is some breakage in the...
I have a customer that wants to be able to have a single nRF51822 sends sensor information to two iphones at the same time. Is this possible? Can you pair a peripheral to...
Hello,
I have a question....
I have real ECG device and I almost got PCA10001 development board. Studying about PCA10001 I noticed that this board has ADC. I downloaded...
