Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
Could someone give me a hint with the following problem?
I am using two example projects (ble_app_uart_c, ble_app_hrs) to connect a central and a peripheral.
An...
I am trying to understand the operation between BLE device & android application...
After "CONNECT_REQ", I can see several "SERVICE PROFILES" but I can't find those UUID...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hi,
As I’ve mentioned in a previous post (answered ! Thank you Aryan !), I'm writing a bootloader for nrf51822 to be able to update the nRF51's firmware through SPI (data...
Dear community and support,
I am trying to install Master Control Panel 3.9.0.6-x86 on a Windows-XP virtualbox. The installer fails with the following message :
"The installer...
I want to send a float as a value of a characteristic.
As I know is this all what I have to change to send a float...
float temperature;
uint16_t len = 20;
attr_char_value...
Hello,
i have an urgent problem that i need help.
I have designed a board using nrf8001 IC and manufacture 5 samples. They are working perfectly.
Then i went to production...
I am using the S110 softdevice from v8, and building the bootloader from SDKv8, using keil uv5.
The project is dfu_dual_bank_ble_s110_pca10028, loaded from the dfu_dual_bank_ble_s110_pca10028...
Hello, Greetings, in the nRF24L01 datasheet, it's mentioned that the module can work as a multiceiver using the six parallel data pepes,my question is that if it is possible...
on an arduino+redBear Shield 2.1, I read an analog port and write the value to the serial monitor and to my bluetooth connection with
ble_write(analogRead(0));
Serial...
I can't find anything related to this in the docs :(
In the client_handling.c is a function static void on_evt_hvx(ble_evt_t * p_ble_evt, client_t * p_client, uint32_t...
I have been unable to get an ISP130301 module to work with the example dfu s110 bootloader. Dual band, single bank, all of the sdk and SD variants. I've followed the tutorial...
I want to store sensor measurements taken every 2.5ms persistently. Does a write to the internal flash happen faster than this? Can I safely assume that the internal flash...
