Hello, I am working with a nRF54L15 and using a TF-M build (cpuapp_ns). SDK and toolchain are currently v3.0.2. NRF_SECURTY is enabled (by default) and here's the relevant...
Hi,
I’m working on a Matter application using the nRF Connect SDK v2.9.2 . I’ve added the AirQuality cluster into my device with sub-sensors: CO₂, PM1, PM10, TVOC, and Temperature...
Steps to reproduce the problem
Create a new application based on the Matter Light Switch example of the SDK 3.0.2
In prj.conf set CONFIG_CHIP_FACTORY_DATA_BUILD=n
...
I would like to do a FOTA using bluetooth and external flash memory on nrf52840 board. I am also using sdk 2.9.1 The issue i am currently facing is I get the below when i...
Hello nordic community,
i have custom board that have nRF5340 and nRF7002, our requirement is to use wifi every 5 minutes (connect send data and disconnect) but randomly...
HI,
I am using the periodic_adv_rsp example from version 3.0.0. I would like to ask how to switch channels and transmission power in the example code?
Thanks.
In our development using NCS-2.6.1 it is desirable to have logs using BT NUS.
"Serial Bluetooth Terminal" android application is used.
For testing purposes NCS\v3.0.2...
Hi
wil it be possible for you to compile gzll_iar.a for SDK_v5.2.0.39364 ?
I have an aplication running whre I need gazell functionallity; and I have trouble converting...
When I would like to change advertising interval, should I execute sd_ble_gap_adv_stop & sd_ble_gap_adv_start again?
Is there any way to update its interval without stopping...
We will be using nRF51422 with S310 SoftDevice for our development.
ANT for mesh network implementation as that's what it does best, and BLE for interfacing with mobile devices...
Hi,
maybe i have a silly question, but i didn't programm timers before. I know how they work. But how is it possible that there are only three Timers in the 51822 and so...
hello
I am a BEE undergrad student currently doing a project using the nrf51822 Eval-kit.
If you could help with a simple transmitting code. I have to take data from a sensor...
Hi,
I uploaded the app to the kit as I have been doing it for the last 2 months and from now there is no way to get back to advertising mode. Before, I used the nRF Master...
my purpose is like that:i want to collect some useful data from external sensors before initial BLE ,and when the the nrf51822 advertising,i send this data out to the smartphone...
Hi,
I am trying to use the PCA10004 board in a custom application without the use of starter kit.
When I burn the nRF51822 chip with my custom program, in my custom hardware...
2mA in ON mode (IDLE) far too much.
One timer should running to wake the device up after one minute, to take a measurement before going to sleep.
nRF51422_PS_v2.1 ...
I've had an iBeacon-like app running great for months and am now entering limited production so it's time to protect the code. Enabling "Lock entire chip from readback" in...
Hi,
i need to write a linker script for using S130 in my project.
in the moment i don't want to use a boot loader so maybe some one can help me with the correct addresses...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
