Suppose there are 10 BLE peripherals in a room and one BLE Central,then is there any way i can get the list of available peripherals[name or id.. etc]?
I am using NRF5182...
I am using SDK_11 s130 on nrf51-dk. When err_code is any value other than NRF_SUCCESS, APP_ERROR_CHECK(err_code) will cause nRF51-dk board to reset. How can one get APP_ERROR_CHECK...
Hello All,
I have problem with ble_app_uart which are not support DFU services.
When I am implement both services device will not advertise. and when ble_nus uninitialized...
[symptom]
I want to update my application/bootloader/softdevice by DFU.
Steps are shown below.
bootloder/softdevice update
if 1 step is done, application update...
Dear Developer Zone,
I am new to ANT and am looking for someone to help me to setup an example 15 channel (14 devices) ANT network using the S332 soft-device to test communication...
Hello,
i am working with the Enhanced ShockBurst proprietary protocol and i am wondering where I can find the sources of this protocol, so that I can do some changes. ...
[uart - Copy.rar](/a master _error.png ttachment/3cc01f5e2484d2b0f33e62befd3e6a62)
hello there
I am interfacing master nrf51 dk with nxp's slave lpc11u24
(1) my main...
I've studied the nRF OpenMesh for a couple of days, and could run the BLE_Gateway example among serval nRF51DK boards.
But now, I still don't have any feeling/concept about...
Hi, I’m looking for a data streaming solution to wirelessly transmit data over a short distance. Important points are:
unidirectional point-to-point transmission
...
Good morning,
my problem is that this module has a very short range.
The maximum range that I found was 4 meters.
Have you any solution for increasing this range?
Thanks...
Hi,
I saw several structs that you have in your library and I am curious as how you are forcing the alignment, since I want to do the same.
This is one of them:
typedef...
We are currently working on NRF52 DK.
I know that a Segger RTT is used to print the debug message using a Real Time Terminal(like TeraData or Hercules).
I know that...
Hi :)
I developed my Bluetooth app with MBed and the RedBear BLE nano module. My jumper wire installation connecting an stm32 with the module is working great and everybody...
Hello,
what is the initial output state of the comparator in single ended mode, if the input voltage is between the upper and lower threshold?
Is it undefined, always...
Hi,
I have a question regarding the nrf52 UARTE driver. I have the basics setup and working, I can send and receive data using the UARTE.
What I need to do now, is find...
Hi all,
Someone, please, can give me an information about programming a board nrf52832 using the pin SWDIO/SWCLK.
There is an application note that explain this topic...
I don't know where to submit these things.
I don't fully have my DFU working yet, but clearly I have a badly formatted init packet. However, the resulting behavior was...
If an app is advertising on all channels, and receives a SCAN_REQ on 37, will it transmit the ADV_IND (and potentially SCAN_RSP) on 38 and 39, or is advertising interrupted...
I am attempting to use sscanf() on nRF51822. However the chip simply freezes when reaching that part of the code. Do I need to add anything in the toolchain to make it work...
