Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
Hello, everyone~
I'm trying to use mac to develop nRF52832 DK. I have installed the lastest J-Link driver and SES. I downloaded nRF5 SDK 14.2.0 and just open ble_hrs project...
I get nrf mesh SDK form: http://www.nordicsemi.com/eng/Products/Bluetooth-low-energy/nRF5-SDK-for-Mesh/(language)/eng-GB
I want to use the serial example to control a mesh...
I use the advertisement timeout to shut down the MCU. Is is possible to reset the advertisement timeout on the fly, e.g. if there is any activity I would like to extend the...
Hi,
I'm interfacing acceleration via BLE using NRF52.
I'm using timer to get the sensor value and update the characteristic value related to this sensor using sd_ble_gatts_hvx...
Hi,
I tried to make a software update (I tried application, bootloader, SoftDevice and any combinations) over BLE using the secure_dfu_ble_s132_pca10040 example but after...
Hello. I have a problem. After using nfc, current consumtion still high. I found that I need use HAL_NFC_ENGINEERING_A_FTPAN_WORKAROUND macros. But when I specify this macros...
Hi All,
I am going to get EMI/EMC testing for my custom board made on nRF52832 WLCSP package. Can you please share/suggest the firmware used in EMI/EMC testing.
hi everyone
i want use s130 with my ble nrf1822 i'm wondering about the modifiaction that i have to do under keil 5 in option for target for example the configuration that...
Hi,
I try to use the dfu update OTA with ble secure bootloader.
If the Flash is erased and only the SD v5.0.0 and the own Bootloader are programmed a update OTA is working...
When making a bluetooth mesh network, what is a good rule of thump for the ratio between servers and clients?
I am thinking of implementing the server-client-model scheme...
Hi Engineers!
We used SDK13 for our Project (multilink BLE with 1xServer & 4x PeerS) and now move to SDK14.2, almost done except only USBD.
if we use SDK13 driver...
I've already tried before using ADXL345 using nRF51822 using mbed compiler this is the link.. os.mbed.com/.../
but that program can't get ADXL345 data, just UART nRF51...
I'm trying to debug a project I recently migrated to eclipse but my Peripheral Registers are empty with the error message "There are no peripherals descriptions available...
I'm building a new application based on the no softdevice template example. I pulled in the code from the UART BLE example to redirect printf to the serial interface and that...
