Hi, I have a question about Channel Sounding. For my design, I want to use 2 antennas on the initiator and 1 antenna on the reflector. My initiator hardware has an RF switch...
Hi,
We need to write binary content from a binary file (.hex or .bin) to a specific area of the external flash (QSPI).
According to this topic: , this is similar to our...
Using nrf sample from v2.9.1/nrf/samples/crpyto/rng Configure build with v2.9.1 SDK/Toolchain Configure build with board target: nrf5340dk/nrf5340/cpuapp Add MCUBOOT support...
I want to verify the 4Mbps transmission mode of the nRF54L15 series through ESB samples.But the highest value measured so far is 2.34Mbps, which is much lower than 4Mbps....
Hello,
I am currently using nordic connect sdk version v3.0.2 which seems to be the latest release on github. I am using https client example. As per the requirements...
Hi, nordic team
There is an issuse happened in my custom board with nrf52833,programming in ncs v2.9.0.
peripheral side is programmed base on peripheral_hid_keyboard and...
Hi all,
We are currently developing a modem application for use with a Linux host, based on a nRF9161 using nRF SDK 3.0.0 and toolcahin 3.0.1
When compiling the Serial...
Hello,
I cannot use the nRF Sniffer because it is always crashing. This is a confirmed bug in the Software and the OSX client written is working flawlessly.
I have experimented...
Hello,
I am newbie with KEIL/SEGGER, I have been following this tutorial to compile the example experimental_ble_app_blinky_pca10040_s132 for my nrf52 chip, the project...
Hello,
I am using sdk 12.2.2 and nrf51 dev kit. I am trying to upload ble_app_gls example code over the air to nrf51 dev kit. I can find only secure_dfu code in the sdk....
I am considering build some of my own shields to interface with the nRF52DK for the 832 and 840. I am curious how I should use header P5 with the shield detect pin. Should...
Hello,
I am trying to implement my custom service with NUS. I have gone through almost all the solutions presented on this forum.
Observations:
The board does...
Hi,
I need to be able to change the GAP parameters of my connection for only a short period of time to save battery life but have high throughput when I need it. My firmware...
Our workshop is using custom PCBs for other manufacturer's developer kits, and I'd like to do a similar shield for our nRF51-DK boards. Can anyone provide a KiCad project...
Hi all,
I took the example SPI program and I am trying to add UART code to it to debug the SPI transfers. Both examples are working well for me separately. I was able to...
I am working one one star network system with NRF24L01+. I got success with one pair (Single TX and Single RX) on communicating. But I could not get any positive result for...
Hi,
I'm working with an SPI FLASH chip that has a page size 256. I noticed that when I call nrf_drv_spi_transfer() , the rx length of 256 rolls over the uint8_t container...
Why the SPI clk doesn't work, i checked using an oscilloscope :/
I also don't get any SPI interrupt and no data change in the RX buffer although I have wired MISO and MOSI...
