But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
I want to generate a sine wave using the nrf pwm library and a timer CC instead of a delay that is used in the sine example here to get better accuracy.
It basically...
Hello,
I am adding an extra characteristic (of 6 bytes) into one of the services that exist in the default beacon app. Then I try to update this characteristic using master...
Hello Guys,
can someone help me solve this problem (see picture below). Apparently Keil is missing an RTE and CMSIS component. I don't know where to get them. I installed...
Hi
I am trying to get to the bottom of a problem I am having with sending a buffer of data on connection and indication enable.
Here's what I do:
I have a process running...
Hello Everyone,
I am trying to use a display (through SPI) in a custom board with nRF51822 and SoftDevice S120. All works great as long as I call the SPI methods from main...
We have the HCI DFU working. The PC sends the new hex image (python script) via UART to nRF51822. Therefore, the bootloader code on the nRF51822 works. However, in the final...
Hi,
i'm using s130 central/peripheral. I want to send data from my central nrf51822 to my peripheral nrf51822.
I declare write function like this:
static void writeChar...
I'm fairly new to nRF51 development and have started looking at the soft devices. I've had a look over some examples, but I feel the code isn't always clear about what's required...
I am looking to migrate to SDK 8.1 and S110 V8.0 and going through all the implications of that move. One key one is the current Bug with Radio Notifications on S110 v8.0...
Hi everyone,
I am a new here~ If I asked some stupid question, please easy on me.
Currently I am doing a prototype with nRF51822 chip. I know that the official programming...
What is the purpose of the TWI overrun flag given that the TWI peripheral only supports master mode?
I have the following code in an ISR for my TWI acting as master.
...
Hi guys. I have a nRF51822 reference design board which is based on low voltage mode circuitry (using 1.8V supply directly). However, my Segger Jlink (SWD) does not work while...
By default, S110 advertises in all three advertisement channels. I need to limit the advertisement channels, so that I can advertise on a single.
In a similar question...
