Hello,
I'm starting a new nRF51 project on mbed for a custom board. I wish to know what is the "cleanest" way to define pinout (what file to edit) ?
Thank you
I have enabled data ready interrupt bit and also enabled the fifo bit and also enabled gyro_fifo and accel_fifo bits in mpu6050 so that when data ready interrupt occurs the...
I will be selling various ble products. My customers can connect to and program the devices using their bluetooth smart phone or tablet.
I want them to have the option...
Hi,
I am trying to run nRF24L01+ in default configuration using simple ping-pong examples using RF24 Arduino library.
The problem is that while ping-pong is getting through...
Hi,
I want to send data from one peripheral(nRF51 DK) to multiple Android Phones. This will be a one way connection from the peripheral to the smartphones. I red on the...
I am working on "nRF51_SDK_8.1.0_b6ed55fnnn\examples\ble_central_and_peripheral\experimental
\app_s130_demo\pca10028\s130\arm4" project .
In this project,in which variable...
Hello, I would like to know if there is any way to avoid bootloader start in secureDFU firmware transfer. All the checks on init file and control point are on the application...
My DFU is staying in the bootloader, even after successful download of the application package.
I have modified the secure bootloader for my custom PCB (removed the GPIO...
Hi,
I'm trying to get OpenOCD flashing to work on Windows using the FTDI 2232H adapter and an NRF52 target. I found this site:
https://www.allaboutcircuits.com/technical...
Hello,
I am trying to read multiple registers from a slave of i2c.
The values that I capture are the first value repeated in all the buffer.
The number of readed reg...
Hi,
I would like to use ping pong mechanism to prevent faulty application update on nRF52840. Is there a way to build a single image to run at 2 different addresses? How...
I have OSX Sierra, VMWare Fusion and Windows 7 available.
I do Arduino (Teensy) dev, staying on the OSX side.
I want to use the nrf52 chip as a MIDI over BLE conduit ...
Hello,
I have a PCB with a NRF52 powered by batteries. We need to be able to plug the batteries, then program the device and never remove the batteries.
We noticed, that...
I have a need for an interrupt to go off at a 4khz rate. For this, I am using a repeated App Timer (running off the 32k crystal).
Prior to adding this extra timer, we used...
I'd like to run the DK in at the lowest power in SYSTEM_ON mode.
It's my understanding that the ble_app_gzll example places the system in the "low power" SYSTEM_ON mode...
Hello Folks
I would highly apprciate if anyone can point me in the right direction here
After lot of consultation we imported a smal size shipment (of about 1000 nRF51822...
Connection_mode_with_1sec_Notification.jpg
In my BLE project I am using connected mode, and I found that the current consumption is very high ~190uA during idle mode. I...
I'm currently working with an own hardware with a nRF52840. We had some time to get the radio working, because we copied the schematic of the PDK. In the reference design...
