Hi,
I'm trying to get the debugger to work on my target board. I created the attached simple program to eliminate complexity.
The debugger starts, but it starts running...
Hi.
After 3 days I've finally got littleFS working on a custom nRF52840 board. I am using nRF connect SDK v2.9.0 which includes Zephyr v3.7.99 with some additional Nordic...
Hello, I am working with a nRF54L15 and using a TF-M build (cpuapp_ns). SDK and toolchain are currently v3.0.2. NRF_SECURTY is enabled (by default) and here's the relevant...
Hi,
I’m working on a Matter application using the nRF Connect SDK v2.9.2 . I’ve added the AirQuality cluster into my device with sub-sensors: CO₂, PM1, PM10, TVOC, and Temperature...
Steps to reproduce the problem
Create a new application based on the Matter Light Switch example of the SDK 3.0.2
In prj.conf set CONFIG_CHIP_FACTORY_DATA_BUILD=n
...
I would like to do a FOTA using bluetooth and external flash memory on nrf52840 board. I am also using sdk 2.9.1 The issue i am currently facing is I get the below when i...
Hello nordic community,
i have custom board that have nRF5340 and nRF7002, our requirement is to use wifi every 5 minutes (connect send data and disconnect) but randomly...
We have the HCI DFU working. The PC sends the new hex image (python script) via UART to nRF51822. Therefore, the bootloader code on the nRF51822 works. However, in the final...
Hi,
i'm using s130 central/peripheral. I want to send data from my central nrf51822 to my peripheral nrf51822.
I declare write function like this:
static void writeChar...
I'm fairly new to nRF51 development and have started looking at the soft devices. I've had a look over some examples, but I feel the code isn't always clear about what's required...
I am looking to migrate to SDK 8.1 and S110 V8.0 and going through all the implications of that move. One key one is the current Bug with Radio Notifications on S110 v8.0...
Hi everyone,
I am a new here~ If I asked some stupid question, please easy on me.
Currently I am doing a prototype with nRF51822 chip. I know that the official programming...
What is the purpose of the TWI overrun flag given that the TWI peripheral only supports master mode?
I have the following code in an ISR for my TWI acting as master.
...
Hi guys. I have a nRF51822 reference design board which is based on low voltage mode circuitry (using 1.8V supply directly). However, my Segger Jlink (SWD) does not work while...
By default, S110 advertises in all three advertisement channels. I need to limit the advertisement channels, so that I can advertise on a single.
In a similar question...
I now this are basics. And I did this allready a few times, but in this project it simply wont work.
Maybe someone of you will find something, that is missing.
I`m working...
Examples like the "proximity application" are all associated with the nRF51422_xxAC. The part I'm using is the nRF51822_xxAA. How do I make this examples work with my part...
Hi,
I am wondering what to do to fix the error I have been getting while trying to debug my project. I am using app_trace for logging. I would often get an error on the...
I have a custom PCB with nRF51822. I have copied the "QFAA QFN48 with internal LDO setup" schematic from Product Specification v3.1. However, I have not copied the PCB layout...
Hello,
I am using a custom PCB with ISP130301 BLE module based on nRF51822. The PCB layout for the module is designed based on the recommended PCB land pattern and solder...
