We need to sense temperatures in the upper end of the operating range, specifically in the 40C to 70C realm. We have three different units, and we are finding that the temp...
Hi,
We're evaluating NFC for our project.
I've been testing with a nRF52840DK - PCA10056 Version 3.0.2.
Using the antenna supplied with the Development Kit I am...
Hi,
I have been playing around with the configs but I could not get Mode-3 to activate. What should I change for cs configs and the prj.conf file in order to activate it...
Hello - We're designing a new app for our product in Flutter. I was writing the proof of concept for the firmware updates, but I hit a roadblock with a Mcu Mgr Error: 25 ...
Hi there,
I am using an NRF54L15 custom board and am trying to set up a functionality using DPPI + PPIB. using a single in (1 event) and single out (1 task). I have two...
Hi,
I'm trying to get the debugger to work on my target board. I created the attached simple program to eliminate complexity.
The debugger starts, but it starts running...
Hi.
After 3 days I've finally got littleFS working on a custom nRF52840 board. I am using nRF connect SDK v2.9.0 which includes Zephyr v3.7.99 with some additional Nordic...
Hi,
I want to write flash using received data in BLE interrupt handler(on_ble_evt()).
When i received some data from BLE, i try to write it to flash and wait until done...
Hi
I'm trying to use the nRF52840 USB Serial UART device (aka USB CDC ACM) however I can't find a Windows driver for this device
The VID is 0x1915 and the PID is 0x520F...
I need to copy a string, but i don't know how to define nor how to copy.
This is the string that i have to copy dev_name.p_data.
I use soft device S130 in NRF51
Hello,
using the nrf Toolbox and the UART menu I can connect to my nrf52 and if I navigate back to the initial screen the iPhone disconnects but the GAP_EVT_DISCONNECTED...
Hi, I have a peripheral device which has buttons that connects to a central device which is the NRF52 board. When the peripheral device is connected and buttons are inputted...
Hello. I am at the point in my project (using sdk v12) where I need to get DFU implemented.
In my case, DFU must occur through an alternative transport that is none of...
I'm using SD132 as a central, that I want to connect to a custom peripheral device.
I first add the 128-bit base UUID with: sd_ble_uuid_vs_add(&mys_base_uuid, &p_mys_c...
I'm having a lot of trouble trying to program both an application and a softdevice (S132) onto my board. If I use nRFgo to program the softdevice, then try to program the...
Hi I am using sdk 11 and adding DFU to my application
My application always stuck at dfu_ble_svc_peer_data_set(&m_peer_data);
in function 'static void dfu_app_peer_data_set...
Hello all,
I try to instantiate an uart driver using NRF_DRV_UART_INSTANCE macro, but I got the following error :
sdk/components/drivers_nrf/uart/nrf_drv_uart.h:97:1...
Hello,
We are developing an application in which we have an NRF51822-CFAC with sd110 v7.0.0 together with very small energy allowances. Our problem is that we cannot get...
On an ble advertising timeout an event is dispatched to : ble_advertising_on_ble_evt(p_ble_evt)
I notice the application restart and suspect it due to :
ble_advertising...
