I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hello
I have an application to process advertising report even if it is duplicated.
Is there any way to control whether the soft deice shall filter
duplicate advertising...
Hello,
I am using the example "ble_app_beacon", I have compiled and tested (all works well).
I am wanting to add more data to the scan response by passing more data to...
I'd like to run a softdevice application with OTA support on a RIGADO BMD-200 Evaluation board . I've successfully flashed the softdevice, the app, and the rigado bootloader...
I have a simple application which pretty much consists of the following main function:
int main(void)
{
SOFTDEVICE_HANDLER_INIT(&clock_lf_cfg, NULL);
ble_enable_params_t...
Hi,
We're working on BLE communication between iOS and 51822 and found a data reliability issue. We have a custom characteristics that iOS read 60 bytes data from 51822...
Hi,
I have made some changes with how we update tick timer inside FreeRTOS and the results are promising
.
The improvement is
RTOS tick will auto correct if masked...
I went through a similar post for nrf51 which explains the numbers pretty well ( devzone.nordicsemi.com/.../) . I wanted to know what the values are for nrf52. The internal...
We have a nrf51822 device that has to send 6 bytes back to back at 12K8 and 6-18 bytes at 38K4 in the future.
The bytes are in an array and do not need to be generated...
Hi experts,
I have just tried lbs example. I saw in the ble_lbs_c.h, the base uuid and service uuid are defined for the peripheral peers who are going to be connected....
I'm developing with nRF52, SDK 12.2 and softdevice s132 3.0.0 . I modified the saadc_ble code from github which uses SDK 11.0. It seemed to work fine. But disconnection happens...
Hi,
I adapted the ble_app_multilink example to continuously scanning for ibeacons and collecting rssi data.
Data are then sent via UART to a microcontroller which provides...
Hi everyone,
Im new in embedded world so first sorry for maybe stupid or basic questions... Also there is not a lot of information about nRF52840 and IEEE802.15.4 :)
Im...
As a small team, we have to find silicons from retell market. Sometimes even the trader can not promise its source and batch. Here is a small list of nRF51822 available from...
