We are using nRF51822 for our products.
We want to know the min value of "Receiver sensitivity" when we use this chip for BLE.
The Datasheet says "Receiver sensitivity...
Dear
The BLE Multi-link example (ble_app_multilink_central and ble_app_multilink_peripheral)
shows how one central device can connect to multiple peripheral devices. ...
In the MCP app, if I have the following service data for an Eddystone beacon:
0x10, // Eddystone-URL type
0x00, // TX power in dBm. This is a signed integer so 0xEE ...
I have the nRF Control Panel Android application. It works fine with several BLE devices, but specifically for the Fitbit Flex, it fails to connect.
I know Fitbit wristbandes...
Hi,
The situation:
I was able to successfully receive known packets from a device running gzp_device_dynamic_pairing, from, the host running the gzp_host_dynamic_pairing...
Hi everyone
nrf51822,softdevice s130 2.0.0
now i used softdevice s130 establish two connection as a central with two s110 peripheral device,at the same time i establish...
Hey, what i'm trying to do is the following:
- Advertise The unique MAC-Addresse
- Scan and connect to a Peripheral Node with a specific MAC-Address
But it isn't working...
Hi Guys!
I have nRF52840 Dongle (PCA10059) 1.2.0. I downloaded Nordic exmaples repository. I try to however start and load any HEX file with program from Nordic repository...
some questions for power consumption of 52840.
We've planned to use about 10 to 30 nRF52840 devices for advertising TX mode. One scan mode device which is connected with...
I have a device based on the Nordic nRF52832. I am using softdevice s132. I am using Nordic nRF5_SDK_15.3.0_59ac345. My Android device I am testing with is running Android...
I recently bought a reel of nRF52840 and received rev C0 (Which is Engineering C). We require long range in our solution (Coded PHY). I was reading the compatibility matrix...
Hello,
I'm trying to stream data at ~ 30KB/s rate. I use nRF52840 development board with S140 as peripherial and smartphone with "nRF Connect" app as central. UART example...
Hello, Nordic.
A while ago, debug terminal do not appear in Segger Embedded Studio, and nothing happens when I click View -> debug terminal in the tab bar.
Currently...
As far as I understand, the nRF52840 USB dongle can be flashed via USB if there's a DFU capable bootloader installed (and it booted *into* that mode).
Once I got the dongle...
Hi
Good day!
I am new to this BLE module. I have worked out an application using nrf52 DK (nrf52832 SoC ) and now I want to use Ebyte module E73-2G4M04S1B which is based...
Hi team,
I am using nRF5_SDK_15.3.0_59ac345 and nrf52832 controller. I am using nRF5_SDK_15.3.0_59ac345/examples/ble_peripheral/ble_app_uart example code and the hardware...
Hello,
Please check my schematics with PA / LNA.
I have problems activating PA / LNA, the connection is very difficult when using the battery, I am forced to use external...
Hello,
Every time I try to run any example I download online for my nrf52832 board I get dependencies errors after locating the project folder to the sub "examples" folder...
I am trying to get battery % from the thingy91. I have the AT command AT%XVBAT running successfully. It returns what I assume is millivolts. However these value are higher...
