Hi,
I use the nrf51422 chip.I want to know if the ANT establish link between chips,where can I get the matching configuration (like device type、channel ID).I mean is...
Is there a way to recieve more than one write callback for a given characteristic, per radio session? It seems like I can rx 1 time per attribute per radio session and tx...
If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
I am trying to setup the hrs sample with gcc (4.8.3) and Eclipse Kepler but althoug it compiles fine the editor is complaining about:
Symbol 'softdevice_evt_schedule' could...
I follow devzone.nordicsemi.com/.../can-nordic-please-document-how-to-debug-code-on-their-processors
and add retarget.c and
retarget_init();
printf("Start...\r\n");
to...
I am running 5.2 sdk's UART under experimenta\ble_app_uart,
I assume it works with www.nordicsemi.com/.../nRF-UART-2.0-for-Android-4.3
when Android app sends data to device...
Why does this simple float arithmetic cause my GDB client to hang and my GDB server to say "GDB closed TCP/IP connection"? I'm sure I've got other float operations working...
Hi,
I know the flash operation, including earse and write, should be excuted when the radio is inactive.
So, I put the flash earse and write operation into the function...
Hello,
I have Nordic nrf51822 evaluation kit. Can you tell me how can I send 'Hello, Wake up' message from Nordic nrf51822 evaluation kit (pca10001) to nrf usb dongle kit...
Im getting the following error ,when I try to compile the example ble_HID_template from the latest Arduino Nordic Release:
ble_HID_template.ino: In function 'void aci_loop...
-- When a ble peripheral starts advertising and then receives a BLE_GAP_EVT_CONNECTED event, the stack stops advertising automatically right?
-- When you get BLE_GAP_EVT_CONNECTED...
Hi
I have successfully created services and characteristic from nRFGO Studio and they are advertising well even receiving and transmitting is going well. Now my problem...
Hello,
i ported example of mouse by HID for nRF51822 to nRF51422. The device is detected as mouse by Bluetooth in Windows 7 but I cannot to connect it. Any ideas whats wrong...
Hi,
I'm wanting to develop some solutions around the NRF518222 IC. I want to try out the various modes etc, bluetooth and ANT as well as trying to get some longer range...
I try the throughput in S310,
I refer the "nrf51-ble-app-lbs" to make our code(interval is 20ms),
and test with Master Control Panel.
it seen only have 1.7KBps.
Could...
Hi,
I am trying to detect if a disconnection occurs due to a signal loss.
In the application's BLE Stack event handler, I have found that there is a disconnect reason...
