Background
Our device uses the CONFIG_LTE_NETWORK_TIMEOUT option from LTE Link Control, which by default is set to 600 seconds (10 minutes). I haven’t found any specific...
Hello, as the title suggests, I have an issue when powering the nRF9151 DK with an external power supply. Normally, I power through USB, and it's fine. However, when I followed...
Hi all,
I am using and nrf9160, in particular a thingy91. It is running 1.3.7 firmware. I have the SLM sample loaded and can sent AT commands to the device using the nRF...
Hello,
We are working on Zephyr sample app Mesh on nRF52840dongle with nRF Mesh application.
After going through the documentation and few other Q&A on the portal, I was...
Hlo
I have to asked that i am working with custom board of nrf5340 and i want to flash and check the rf signal by flashing through the nrf5340 development board and i am...
Hi all,
I'm encountering an issue with the TWIM30 interface on the nRF54L15 (pins P0.03 - SDA, and P0.04 - SCL), using vanilla Zephyr v4.2.0-rc1.
The setup involves external...
Hi,
I purchased a Qorvo QM33120WDK1 UWB development kit that uses a Nordic nrf52840-DK. I have been using this DK for weeks without issues, but the last time I used it...
Hi,
I have a C# app connecting to 51822 devices, doing data/firmware download. When I try to send erase page command (before write), erase works, but there is a disconnect;...
Should we keep track of this by monitoring the write events or poll the gatts value via the softdevice?
It looks like it's faster (+shorter = less consumption) to monitor...
Over the past few months I have worked extensively on a few different projects that all utilize the nRF51422. In some recent debugging of GPIO issues (both relating to SENSE...
As the title says, I am wondering when the new SDK will be released to support the nRF51822 hardware revision. It looks like the latest (v4.4.1) doesn't have anything new...
the very similar issue
Friday, October 04 2013, 02:23
I have staerter kit + development kit. I have installed all required software and can't loat example code because...
I Every one !!! Thank for the possibility to participate in this forum.
I am trying to initialization configuration of my nRF24L01+ .
I am using CY8C3866AXI-040 from Cypress...
Hi, i'm experimenting RTC1 using the app_timer module (not using S110 soft device), and i find some problems onRTC prescaler. If i set values as stated in the datasheet, for...
Hi,
I am trying to run several applications sequentially on the nRF51822.
I have another microcontroller controlling the nRF51822 by SPI.
I init the stack, the services...
Hi, I'm just wondering if there's a reason that the example code is always initializing all structures through functions. Has it something to do with sleep mode and RAM retention...
Hello,
I have a couple of questions about sending multiple notifications:
I want to send multiple notifications (from same characteristic), is that allowed by...
Looking at the AN36 code, i notice that in the APP_SCHED_INIT define, for the argument EVENT_SIZE is used sizeof(app_timer_event_t) . In the meantime, the scheduler is used...
Hi guys,
I was wondering if the nrf51822 can listen to data packets being sent over by the nrf24. In the datasheet they say it supports nrf24 protocol. But what exactly...
I have a nRF51822 module programmed for custom service and characteristics. I am able to connect to this module using android 4.3 API. I can get characteristics and their...
