Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
I set up nrf52832 that it is called proxy device, i create a loop that proxy device will sent 20 message to app phone (Android) within 100ms. But my app (Android) receive...
So I'm not sure that this is an error, but it is a little annoying. I have an application that sends sensor data using ble_nus. Works great, except that mixed in with my data...
To the kind attention of Nordic support team,
In case of a device and host ble bonded, I'm giving a look at disconnection reasons codes due to (1) host entering sleeping...
I have build a project, and it has been running normally. Now, I want to test a font data, so I created a function. But strangely, although the compilation has been successful...
We are developing iPhone application that configures mesh boards. If we try to send several messages in a row (specific case: trying to distribute application key and then...
Hi,
I have NRF_LOG configured with a RTT backend. This works great while debugging, but during beta-testing in the field there is no way to access the log.
Is it possible...
Hi,
I am a bit confused about the effect the Connection Interval has on BLE throughput.
SoftDevice documentation :
https://infocenter.nordicsemi.com/index.jsp?topic...
Hi,
I've implemented a program on the nRF5 SDK, based on the ble_app_att_mtu_throughput example, that sends out advertisements in between periods in which it scans for...
Hi,
We are using nRF52833 chip for our development. We need to combine Application, Softdevice, Bootloader and setting file for production purpose.
In project merging...
The nRF desktop tools are great but all have an irritating bug. I typically hibernate my PC at the end of the day to take it home. When I restart the next day, the windows...
Hi,
I'm trying to link a static library that provided by others to my own project. I followed the steps in this post ( https://devzone.nordicsemi.com/f/nordic-q-a/39338...
Hi all
I'm using nrf52805 soc, softdevice s112 , sdk version 17.0.2 and nrf connect mobile app for my project development. I can connect and disconnect the nrf52 device...
Hi,
I am using P0.10 GPIO of nRF52840 (QFN package) as an output for driving a transmission circuit with an 8MHz digital signal.
According to the datasheet this pin is...
Hi team, I'm using Mesh in my project. Using this thread as a reference, I tried to decrease the data throughput and experiment to see if devices could communicate with each...
hello,
i want to know if is possible have Multilink, ble Uart and relay together? it is for make an a type of Mesh network of 4 devices with a BW of 1Mbps (see the image...
