Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi,
We would like to pass radio certifications and our lab is asking for different tests modes (TX/RX continuous, waves etc ...) regarding BLE and NFC.
Regarding BLE,...
I'm using SDK 12.3 and SoftDevice S130 2.0.1 and trying to secure a BLE link with OOB.
The nordic board is running as a central and makes a new bonding to a peripheral every...
Hello, all.
First, I don't live in English country. So, My sentence may be false.
I want to develope ble communication without pairing.
In this status, I will communicate...
while using example buttonless DFU in sdk13.1, writing to flash using flash_word_write() is preventing ble connections, even though ble is advertising.
can anyone help...
I want to generate an interrupt event use pin30 when it goes from low->high or high->low.
First I register a gpiote user by
app_gpiote_user_params_t app_gpiote_params...
I found out answers for calculating data rate during connections, which depends upon connection interval, no of packets allowed in each connection and no of bytes in a single...
I am trying to stop RTC by pressing one button and wake up again by releasing the same button.
My RTC now runs around 4 uA while being on system-on sleep mode by __SEV();...
Hi,
I managed to get dfu working in application (with hrs). But on the last attempt to erase page with bootloader settings there is no event generated from softdevice and...
dear all,
i need your help.
Where we are:
We use mbed software developer platform.
We have BLE Nano V1.5 + MK20 USB Board V1.0 from RedBear.
We are able to generate...
I would like to know how frequently my peripheral is sending advertising and data packets. I've tried using ble-sniffer-osx but it doesn't actually reveal any device names...
Has anyone successfully used the Android-Beacon Library to detect the nRF51822 Beacon on and Android application? I tried several different layouts but I just can't detect...
Hi everyone;
i think about possibility of using nrf sniffer with custom nrf51822 (QFAA) board . if yes, how can i achieve? could you please help me about it
Best Re...
