Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
I am developing an application on nRF52 wich simultaneously acts as a central and peripheral and I am using the Peer Manager to manage bonding. The central needs to stay connected...
I have the PPK measuring a custom nRF52-based board. The board consists of the nRF52, a I2C sensor, and bunch of caps (210uF worth). We built a custom board to do current...
We highly anticipate it will but wanted to ask here before we might ask Nordic Support to confirm that the nRF52840 will make use of the ARM TrustZone CryptoCell to provide...
I'm looking to design power management circuit for a 3.7V Li rechargeable battery powered wearable sensor design. Any such reference design would be greatly helpful!
Thank...
I'm developing a device that's supposed to establish an encrypted connection with an Android device and I've gotten PM_CONN_SEC_ERROR_PIN_OR_KEY_MISSING during connecting...
I have the Type 4 Tag sample application running and I can read and write the tag without any problems.
I'm getting a little confused reading through the sample application...
Hello,
I am working with the GPIO tasks and events feature on my nRF52832 DK. And I noticed some strange behaviour. I want that two Pins will toggle if some timer events...
Hi,
Please help me with the following theoretical situation:
I have a NRF52832 running HID profile, mostly sleeping.
From time to time, an external interrupt occur (GPIO...
Hi,
I am trying to get the data written from a central (a smartphone in my case) to one of the characteristic of my peripheral using write request. The problem is that...
Dear developers,
We had a working application with SDK11 SD2.0.1 that we have migrated to SDK12 SD3.0.0. With SDK11 we could successfully bond to multiple peripherals and...
Hi. I use the nRF51882 and Arduino ide for developing. My main goal is turn on and off the Led thru the Bluetooth interface. But when I use the UART service for it I have...
I am seemingly haunted by spurious 'soft resets' I cannot seem to find a good explanation.
I have an application that is to be dormant until activated. When waking up I...
Hi, I'm a newbie to Nordic and need to use multiple nRF24LE1s to get ADC values and transmit them to a single nRF24L01 connected to an Arduino. I need sample Keil compiler...
