Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi can anyone guide me in configuring the peripherals of nrf51822 before putting the chip into sleep? For example, timer, i/o pins, etc... which is not needed to reduce the...
Hello, please help me to find nRF52 datasheet, in which are recommended WLCSP footprint, and of course schematic drawing of this module. In your Dev Zone I found only QFN...
Hi,
I'm wondering what speed the NRF52832 radio is clocked at internally. is it the main 64MHz clock or 16MHz like the NRF51?
The reason I'm asking is that I would like...
I'm using nrf51 with 16kb memory
I know that there is a region for softdevice, region for the bootlader and region for the app code and a free region
my questions :...
Hi Nordic support,
I'm pretty new to BLE and I have a system based on the UART example.
On the nRF51-DK, a modified BLE UART Peripheral example using SDK 10.0.0....
Hello,
I am working on S110 v8.0 softdevice and SDK9.0 and need to implement whitelist in our application. I am referring to the ble_app_hids_keyboard example project....
I'm attempting to download and install nRF51 SDK from here:
developer.nordicsemi.com/
Note: The links are ABOVE the masthead of the page (very poor layout!)
I...
Hi everybody,
Here are some related questions based on the same bug :
devzone.nordicsemi.com/.../
devzone.nordicsemi.com/.../
I build a test application...
Say, for example, I have a BLE peripheral programmed with S110 on nRF51822. When an Android app connects to it as a BLE GAP central(and becomes GATT client), can any data...
I am trying to get the Device Format Update tutorial to go, but run into a problem while I am programming the using the nrfjprog routine, and the programmer aborts without...
Hi,
My bootloader code was modified to include the device type and device revision when performing the OTA. I used single bank example.
When I made the zip for OTA,...
Hi,
I am working on the heart_rate_collector example code of nrf51-ble-driver_linux_0.5.0.
I received BLE_GAP_EVT_CONN_PARAM_UPDATE_REQUEST event after setting HRM CCCD...
I'm developing some simple wireless temperature sensors based on NRF51822s. In essence, they take a temperature measurement from a sensor over TWI, send it to a base-station...
Hi.
I'm working with Softdevice 8.0 on Rigado's nRF51 EVK.
I've configured a repeated app_timer that works great. but stops just as I connect my phone to the BLE.
main...
