I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello,
I am using nRF52832 DK PCA10040 v1.2.4, SDK_15.3.0, S132 SoftDevice and Segger for flashing the image. I am using ‘ble_app_blinky’.
What for this macro HWFC...
Hi, I'm looking for a PCB antenna design for nRF52832 based on 0.8 mm thickness four or two layers stack up .
I found some examples but based on pbc of different thickness...
Good morning,
I'm designing a new product based on the nRF52840 device (s140) and power consumption is one of the key parameters for my project.
The equipment (peripheral...
I'm debugging some corner-cases with my own DFU process and Bootloader. I believe I hit a race condition in which sd_mbr_command() was called before the source of the new...
I am trying to make a service discovery on a peripheral device using a nrf52-DK (pca10040). I built my project around the multi-discovery example from SDK 15.3.
When performing...
Hey all,
I'm trying to replace the nrf_cli_uart transport layer with the CDC ACM equivalent (nrf_cli_cdc_acm), since I have an nrf52840 dongle and can't use the uart libraries...
OS : Ubuntu
SDK: 15.3.0_59ac345
Base example : peripheral/saadc
HW : nRF52832 DK PCA10040 1.2.1 2017.49 682663245
Hello, i would like to make sure the ADC acquisition...
Hello,
I am using nRF52832, SDK_15.3.0, S132 SoftDevice and Segger for flashing the image. I am using ‘ble_app_blinky’.
I want to check for debounce of a level on...
Dear support,
What are the absolute minimum decoupling cap sizes running the nrf52810? The application is extremely power sensitive and it is not desirable to have any...
Hello
I am trying to add two custom UUID as below ( Platform nRF52) . And the API return error when I call the second time, with a different UUID .
err_code = sd_ble_uuid_vs_add...
Acually i m working on a project which calculates distance using RSSI values , and i am having this doubt whuch examples to refer between ble_central and ble_peripheral
...
Hi,
I want to configure "BLE_GAP_PHY_2MBPS" in ble_app_uart example of sdk 15.3.0 for faster communication, for this i have changed
BLE_GAP_EVT_PHY_UPDATE_REQUEST: { ...
