Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Currently I am facing strange issue in my project. Let me first highlight my set up. I am using the PCA10040 kit for development, keep multi-meter in series to measure current...
hi experts, I want to build a ble center based on s130 to collect sensor data from several peripheral devices. Some of them may not be from nordic solution, such as TI. so...
When I connect to my firmware after cycling Bluetooth on iOS, I am able to subscribe to my Characteristic Indications without any issues. The nRF connect app receives all...
I have two boards, one is official demo board, the other I make PCB board.
I down the open-mesh source code form github.sdk version is 8.1,open mesh stack version is 0...
Hi,
I have to send data with notification from central to peripheral, because I need save some data in peripheral device.
What I have to do ?
I test it on Adnroid 4.4 ...
Hi Sir,
I am working on nRF52832 board with pca10036 cortex M4, and i worked out spi master and slave example code on a same board and configuring spi instance 0 as master...
when using secureDFU with sdk12.2, only changed the mac address.
my application is more than 60KByte,
when i test the firmware for two files, one is 62K and an other is...
hello, im from india im using nrf24l01+ for my project to transmit and receive data between two arduinos. i tried all tutorial basic programs but i cant sucessfully send and...
I made a BLE peripheral (nRF52 + SDK11.0.0 + s132) and have so far been using Android devices (that supports 7.5ms connection events) to connect to it. I want to connect to...
Hello,
We are sharing SPI and we found possible bug in nrf_drv_spi....
The problem was that first SPI is using blocking SPI thus does not use ISR and set it to NULL: ...
Hi, Nordic
I want to add ble_dfu service in my app, my own app will add my custom ble service.
So in service_init() function, ble_dfu_init first callback, then my own...
Hi,
I want to control a g-sensor by nRF52832 via i2c.
I am using an example( nRF5_SDK_12.2.0\examples\ble_peripheral\ble_app_uart\pca10040\s132\arm4)
and I add the app_twi...
Hi,
I use the SAADC to sample 2 pins. I use the nrf_drv_saadc, and a timer to call the sample task.
I was trying out several gains for SAADC and I noticed that for gains...
