Hello,
I'm working with a custom board using an nRF5340 as its primary MCU and NCS 2.7.0. The application I'm developing requires internet connection and can ideally support...
nRF52810 board will not start on its own. It needs the RTT Viewer to be connected, then it will start and run. It has run on its own before with this configuration:
CONFIG_CLOCK_CONTROL_NRF_K32SRC_RC...
Hello,
We are using a BLE module based on nRF52832 with a U.FL connector for external antenna connection. One of our automated tests requires we turn off/on the antenna...
Hi,
I am working on a sensor device that requires very accurate timing on the sensing and sensor signal algorithm side. This device needs a low latency and low jitter radio...
Hello,
I'm looking to get XInput working on the nRF52840 so that our device can appear as an Xbox-compatible game controller. I'd appreciate any guidance or recommendations...
Hi
We are using the CMakePresets.json file for different variations of our firmware. Since the latest update (2025.4.106) the build configuration interface changed a bit...
Hi all,
I've been developing a BLE application on my laptop to communicate with the 52840. I manage to understand how to create and run a BLE connection through the really...
I'm implementing an Android 4.3 app which uses an nRF51822 and the BLE proximity profile. I have the following as starting points for the app code:
The BLE sample...
I can't seem to find the required current of NVMC doing erase and write. The product spec has only timings but not more. Could someone from Nordic provide some figures? Experimental...
Hi,
I have a C# app connecting to 51822 devices, doing data/firmware download. When I try to send erase page command (before write), erase works, but there is a disconnect;...
Should we keep track of this by monitoring the write events or poll the gatts value via the softdevice?
It looks like it's faster (+shorter = less consumption) to monitor...
Over the past few months I have worked extensively on a few different projects that all utilize the nRF51422. In some recent debugging of GPIO issues (both relating to SENSE...
As the title says, I am wondering when the new SDK will be released to support the nRF51822 hardware revision. It looks like the latest (v4.4.1) doesn't have anything new...
the very similar issue
Friday, October 04 2013, 02:23
I have staerter kit + development kit. I have installed all required software and can't loat example code because...
I Every one !!! Thank for the possibility to participate in this forum.
I am trying to initialization configuration of my nRF24L01+ .
I am using CY8C3866AXI-040 from Cypress...
Hi, i'm experimenting RTC1 using the app_timer module (not using S110 soft device), and i find some problems onRTC prescaler. If i set values as stated in the datasheet, for...
Hi,
I am trying to run several applications sequentially on the nRF51822.
I have another microcontroller controlling the nRF51822 by SPI.
I init the stack, the services...
Hi, I'm just wondering if there's a reason that the example code is always initializing all structures through functions. Has it something to do with sleep mode and RAM retention...
Hello,
I have a couple of questions about sending multiple notifications:
I want to send multiple notifications (from same characteristic), is that allowed by...
Looking at the AN36 code, i notice that in the APP_SCHED_INIT define, for the argument EVENT_SIZE is used sizeof(app_timer_event_t) . In the meantime, the scheduler is used...
Hi guys,
I was wondering if the nrf51822 can listen to data packets being sent over by the nrf24. In the datasheet they say it supports nrf24 protocol. But what exactly...
