Hi! I am building an android app for my project. I am using Proximity , UART and DFU from nrfToolbox app. I have 3 buttons on my home screen dedicated for each of them. I...
Dear Nordic employee:
1、 what do I have?
I have a thingy52 develop kit（nrf52832）
2、what is my purpose?
the quality of thingy52 audio demo is not good（iphone7）...
Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi, I am working on project to obtain ecg data via bluetooth. But before that I was trying to see whether I could obtain ECG signals serially through nrf52833. And I tried...
Using nrf5340 with nrf70 on a custom board.
I want to use the wifi interface to send raw wifi network packets (both in associated and non-associated modes).
I have the...
Hello Team,
As we have purchased nRF9151 DK from you, we are not able to import the exact SDK required to develop using nRF9151 DK.
Kindly please let us know how we can...
Keil SDK13 BLE OTA upgrade failure causes the device to become unbootable, requiring re-flashing. How can this be resolved? We are using the bootloader_secure_ble bootloader...
Hi,
I’m planning to launch our firmware based on NCS 3.1.0 . At this stage, I don’t intend to upgrade the SDK for at least two years after the production launch . I could...
Hi,
I am using the nPM1300 PMIC and the LED drivers configured so that:
Green LED = charging status (PMIC-driven)
Red LED = error indication
Normally,...
Hi nordic team, I have tried enabling SQSPI on the system off sample, but the power consumption jumped to 6.3mA in system off mode; I tried to disable the cpulfpr core but...
I'm using the nRF Connect extension for VS Code and running into an issue with Sysbuild where calls to cmake for building the app image and the MCUboot image will use different...
We are evaluating the nRF54LM20B for an embedded audio classification application and are trying to determine whether the Axon NPU can meet our latency and energy targets...
Hello,
I encountered an issue when using BT_LE_ADV_OPT_CODED in the bt_le_adv_param options.
When I enable BT_LE_ADV_OPT_CODED , the device cannot be scanned by other...
