Hi,
I'm using nRF52810 on SDKv14.2 and I have changed the bootloader from 52832 to work for 52810. I could do OTA now. I found that the bootloader there is no timeout when...
Is there a way around the issue where bluetooth communication acting as a pass-though terminates the packet whenever null character is found in the packet.
SDK: nRF5_SDK_12...
Hi,
When creating and adding an characteristic to service, what the meaning and difference between these two variables:
attr_char_value.init_len
attr_char_value.max_len...
Hi all,
I have compiled the ble_app_hids_keyboard example for a nRF52832 on a Laird DVK-BL652 breakout board.
I have a tablet running android 5.1.1 and the nordic nRFConnect...
Hello All,
We are using nrf52840 board interface with wiznet550i.
We try to implement mqtt tls 1.2.we get following errors..
I get certificate verification error -0x2700...
Hi,
i am using SDK v8 with softdevice v8,using master control panel pc application,added custom service and characteristics to application,problem is characteristics value...
Hello, I have recently updated our CLI backend to use LIBUARTE and it seems to be much more reliable. I have a few assumptions I would like to clarify and a few questions...
I am about to start new quite complex project with nRF52 and I thought that maybe it is high time to use freeRTOS port from SDK. As the device is going to be powered with...
We are experiencing some mysterious but very rare events of MCU going into system OFF mode. We are using nRF51822 and S110 v7.3.0. The wake ups are most likely caused by a...
Hi,
We are using nrf51822 QFAAH00 with SDK 110 v10.0.0 with softdevice 8.0.0 in our project, In Application we are using gpio,timer,uart interrupt handler, In main function...
Hi support team,
I'm using nrf52840 with softdevice 6.1.0 and sdk 15.0. I started from the ble_connectivity example as my central and used pc-ble-driver on my host PC as...
Hi,
I´m looking for a Bluetooth low energy proximity sensor with this (or similar) characterisics:
One main (receiver) module and many secondary (transmitter)...
I'm using a custom board based on the Thingy52 board and firmware that uses the BMD-350 module containing the nRF52832.. I'd like to use the internal RC oscillator for the...
Hi,
I just found out that the scanning procedure does not time out in SDK 15. This is because in SDK 15 we are forced to restart the scanning procedure everytime an advertisement...
I am using nRF5 SDK for Thread and Zigbee 2.0.0
I am having trouble commissioning using NFC, either with the nfc_meshcop example or my own code (based on the nfc_meshcop...
Hi we are trying to test the serial boot loader example from sdk 11,sdk 12.03 non of them working while running using nrf go studio it says enter in dfu mode and while we...
Hi, I want to use the p0.18 as a GPIO without being connected to nRESET function. So I removed "CONFIG_GPIO_AS_PINRESET" from the define option in Keil. And then i found that...
Hi there,
due to unknown reasons, my nrf52840-DK (1.0.0) didn't come back up after flashing software to it. Means the LED that usually turns on when you power it up remains...
