Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi.
I have implemented the Central and Peripheral NUS service on two devices(nRF52). Since the central knows the characteristic values, I would like to bypass service discovery...
Hi, I've a timer configured by gpiote to capture with a second 'overflow' capture should the signal stop. I'm not using an interrupt instead the CC[0] value is being used...
I have seen the same issue reported.
nRF52840 DK does not appear as a removable drive named "JLINK"
Done the following.
1- My laptop has only one USB port. So I have...
Hi there, I'm controlling the nrf9160 with a esp32 and I'm wondering if you have an recommended libraries for forming AT commands and parsing the return messages?
I'm running through the nrf9160 dk startup guide and I've updated the application and modem firmware. However, it does not look like the application is accepting AT commands...
I have a BL654-DVK (nRF52840) and BL653-DVK (nRF52833). I have a custom program modified from an example that runs and debugs properly on the nRF52840, and am trying to port...
Hi,
We connect our external Board through P20 from EVB NRF52-DK everything goes well.
We are trying to do the same setup on other computer and we get failures to flash...
Hi,
I'm having trouble with debugging the nRF5340. I'm only using the network core and hence use the empty_app_core project for the app core.
The problem i'm facing is...
Hello,
Ubuntu 20.10, nRfConnect v3.6.1, Programmer 1.4.8. Running appimage.
I get:
" Could not fetch memory size of target devkit: Error: Error occured when get library...
hi,
i am working on " ble_app_multilink_central " in ble central . i have connected two peripheral devices .how to include uart in "ble_app_multilink_central" example code...
I have an issue with getting the I/Os correctly setup for antenna switching.
I am running the radio_test example code with the following modifications.
So far, I have...
Hello
I am new to all of this and am wondering if this is possible, and if anyone can point me in the right direction if it is. I am looking to create an open source project...
Hi DevZone Team,
when I use west to configure a project, build/zephyr_settings.txt always contains
"BOARD_ROOT":"/home/user/test/nrf" "DTS_ROOT":"/home/user/test/nrf"...
I am facing one another problem basically i am sending some AT command from central to peripheral but after some time its hang and wait app_erroc. c (__disable_irq();->while...
Hello, I commissioned a factory to make a sample card reader for my company, they didn’t configure everything, because the SDK given to us allows the device to read-only NFC...
