Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
I am new to Arm and Nordic devices and I am trying to port the Thingy52 firmware to SES so we can add some additional sensors.
I have got the Thingy52 firmware to compile...
Hi Nordic Community,
I follow the below link to create an openthread border router. I successfully send sensor data on things.io.
https://infocenter.nordicsemi.com/index...
I've implemented the nRF52840 QIAA var5 reference design in hardware and it works well. For L2 (10uH) and L3 (15nH), in series off the DCC pin B3, could you perhaps recommend...
Hi
I am using nRF9160DK SLM application to evaluate the MQTT AT command function.
Everything is fine if the MQTT message is the string type shown by the doc.
But when...
Hi,
Is there a way to do OTA secure firmware updates with a Windows application?
I've got some users without Android or iOS phones that want to do updates - and they...
Hi!
I am quite new to Bluetooth and Embedded development and I was wandering if there is a course specifically dedicated to developing a Bluetooth application on this chip...
Hi All,
When working on NCS with SEGGER Embedded Studio Nordic Edition (v5.20b), modify prj.conf will not reflect on rebuild solution.
It seems the IDE doesn't update...
Hello Nordic Team,
i've been evaluating the nRF52833 and i have been having a lot of good success. i have been focused on the SAADC block to ensure it meets my performance...
Hi
Since we need use different C1/C2 (15PF/12PF) for 32.768K XL1/XL2
I check "https://devzone.nordicsemi.com/f/nordic-q-a/37448/asymmetric-crystal-load-capacitors" , and...
Hello,
I'm using nrf connect 1.4.0 and nRF9160 dk
I started testing the aws_iot example. It worked fine with my was set up and was able to see the shadow updated.
...
Hello.
I'm using nrf52833 / SDK 17.0.0
I want to find out SAADC sampling time by using logic analyzer.
However, I still don't know what sampling time is.
In this...
Hi
We are working on the secure DFU. The issue is that the NRF52832 chip resets when switch to the DFU mode. All the GPIOs are turned off during reset. However, one of the...
