I am using esb in SDK 11 and my understanding is that the radio causes interrupts that are forcing and cannot be disabled. These in turn causes software interrupt 10 to be...
I'd like to read and write data to the reserved app data space while in the bootloader. Is this possible with pstorage?
Because the BOOTLOADER_SETTINGS_ADDRESSS = 0x0003FC00...
Hi,
I am using 'pstorage_update' to store data in the internal flash. Whenever the number of bytes that should be written matches the size of a storage block everything...
Has anyone tried to generalize this example to different sized variables? What I would like to do is allocate a data structure, write that to flash, and recall it at a later...
I've a PCA10036 V1, I change the IC to nRF52822 QFAA-B016. With nRF5_SDK_11.0.0-2.alpha_bc3f6a0 and SD: s132_nrf52_2.0.0-7.alpha_softdevice, the programme started but if I...
Hi
We are developing software for the nRF51 with Keil under VirtualBox. Previously we used the PCA10000 dongle with the Master Emulator and MCP without issue. Now, with...
We are using nRF51822 for our products.
We want to know the min value of "Receiver sensitivity" when we use this chip for BLE.
The Datasheet says "Receiver sensitivity...
Hello-
Recently, we optimized our BLE4 transfer settings. With the same device, firmware, and payload, we get better transfer rates on iPhone5,6,7 than iPhone 8/X. On all...
Hi
I'm using the mqtt_simple but I altered the code and added some buttons. Like, change subscriber or topic if I press button 1 or button 2 , things like that. What I want...
Hi,
I would like to set up a wireless communication channel between two NRF52840 DK boards. I checked the Nordic SDK v16.0 and found some examples such as \examples\iot...
Dear All ,
After finaly getting all the other stuff in place I tried to compile the examples in the nrf_crypto files.. All of them are giving error bellow:-
Output...
Hi,
I had some troubles getting a custom HID device to work that has both input and output reports to Windows 10 host. Here is my working example template that might save...
I successfully created a custom model (by modifying the generic on-off model) and implemented it into light_switch client and server examples. The goal was to send and receive...
Hello,
I have implemented functionality that enables me to send messages back and forth between two nodes in the network with a timer (both nodes has a server and client...
Hi I have been using the https://infocenter.nordicsemi.com/pdf/nRF_Sniffer_UG_v2.2.pdf I wish to program my nrf52832 device with a hex. Using the j-link commander tool. i...
Hi - I built and flashed the ble_app_interactive example from both SDK 15.3 and then from 16.0 on to my nrf52840 DK (PCA10056). I connect to a Thingy52, issue the gatt services...
Tried with PCA10036 and PCA10031 on Windows 10. Both show as JLink CDC UART Port (COMx) in Device manager. Tried different versions of WireShark. Tried to erase and copy new...
Hi,
Using SDK 15.3.0 , example "ble_app_hrs_freertos", pca10040 with armgcc.
I want to increase MTU and GAP data length.
I started with MTU to 247, and when I try to...
I'm using SDK 16.0.0.
I wish to use two MEMS microphones to record audio over the I2S interface, and then send it over Bluetooth.
What is the best library to use for this...
