Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
Could someone give me a hint with the following problem?
I am using two example projects (ble_app_uart_c, ble_app_hrs) to connect a central and a peripheral.
An...
Hello,
We're using the UDP/IP/6LoWPAN layers as provided by the nRF5 SDK 15.0.0.0.
After experiencing sporadic issues in communication we have a question regarding the...
Hi,
I am using BLE_Blinky_Peripheral example from SDK 15.3.0 with s112 softdevice. I want to use basic softdevice APIs instead of nrf_sdh libraries for enabling BLE stack...
I am a beginner trying to get a device to operate optimally under a battery. Where can I find a starter code template that would shutdown/disable everything, putting the device...
Hi there,
I am working with the NRF52840 Dongle and have been trying to verify what sort of influence other processes on the chip could have on the radio. Specifically,...
Hello Nordic team,
I'm having some trouble with discovering the characteristics of a custom device.
The peripheral device has a private service with UUID 06000002-0000...
I'm busy implementing a (serial) DFU host, but sofar i'm unable to send a proper init packet.
The bootloader keeps returning an invalid signature error
If i open a .dat...
I am using nrf52840dk
sdk15.3.0 and s140
I want to read a sensor data over uart and then advertise it but the advertising never starts after reading over uart even though...
IDE: Segger Embedded Studio
SDK: 15.2
Mesh SDK: 3.1.0
Im working on adding light lightness model to the mesh SDK and it requires doing an equation like sqrt(x * 65535...
Hi all,
I am working on a ble_app_uart sdk example thereby I can connect the bluetooth of nRf52840 to My mobile. I want to read the temperature and send it to my Mobile...
Hi, I am attempting to set up a nRF52840 DK as a BLE peripheral, and have been following the basic setup instructions at infocenter.nordicsemi.com/index.jsp . However, when...
Hallo everybody,
I successfully implemented on the NUS example the Pairing with the Passkey with the following Peer Manager configuration without LESC.
and the BLE...
I've written a DFU client in python. I'm trying to add the ability to restart a failed DFU without having to resend the whole file. I can see that the init packet is saved...
I cannot find an example project for using the PDM module on SDK 15.3.0. Can you please direct me to where I will be able to find such an example project?
Thank you.
HI,
i am using nrf52840.i am sending 500bytes from peripheral to central with the time interval of 100 millisecs. for 5 minutes its working fine,but after 5 minutes the...
