I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi,
Can any one Explain me the Following Error
GATT INVALID OFFSET in the Clinet(nrf master control panel APP)
I am getting this error when i try to send more than 23...
Hi,
we are designing a module with the nRF52832 WLCSP. As the module will be soldered on a motherboard a second soldering process respectively a thermal exposure will take...
I would like to load the blinky example on the nRF52 preview development kit. When I try to build the project I will get this error:
Error #541: 'ARM::CMSIS:CORE:3.40.0...
Hello, this question is similar to this questions (Scan request packet, answered by John DeWitt and Aryan)
I'm using
IAR EWARM 7.20
PCA10001 V 2.0.0 ...
We are using nrf51822 AB variant(16kb Ram, 128 kb flash). Due to flash size constraints we are still using s110 softdevice v5. Following is the linker script config:
FLASH...
Hi,
I have setup my system for working with nrf51822 with openOCD and STLink to program it. The blinky went well. But now when i try to program it i get the following error...
I have just concluded a three year development using TI's Tiva ARM M4 chips, writing both bootloaders and applications.
I am using an RFduino to explore BLE.
I have...
Hi all!
Today I run tests in a public place (some Art Design College) and it looks that radio environment, that exists in the place, kills nrf51 completely....
My guess...
Hello.
I want to flash DFU bootloader with keil on chip nRF51822-CEAA (256kB flash, 16kB RAM). I'm using s130
The areas i write to are:
IROM start: 0x3C000
IROM...
I was wondering if it would be possible to add an event for Service Discovery (and other similar BLE stack events) that could be detected by user applications. Per answers...
hello there i have two nrf51 dk kits. now i want that one act as central and other act as server.
i want to communicate between two. can you tell me how to do it??
i think...
hello all:
IN s310 multiprotocol--ble_ant_app_hrm example ,I open the macro BONDING_ENABLE, then i compile,there is a error
......\main.c(674): error: #136: struct ""...
