I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hi,
We're using nRF51288 on our product and we're interested to move to nRF52.
We bought the DK (PCA10036) EV board and migrated the code.
We've noticed that the...
Hi.
I am on compiling business now. Last days i tried to do GCC compiling and quite go well. But as always on last part i find an error.
My process:
Wrote code...
hi, I want to use BLUETOOTH for Position Service,
Did nrf52840 or nrf52832 support new feature in BLUETOOTH5?
like (1)LE Extend ADV?(2)LE Periodic Advertising Create sync...
Hi
I would like to write some data to flash directly before powering off. I have a few questions:
What is the best way to know if my write operation has finished...
Hi,
The followings are more like an observation rather than a question..
We just upgraded to SDK 14, and realized that some of the RTT logs were mysteriously disappeared...
Our application is running as a peripheral on a nrf52823 with SD132.
It starts running with slower connection interval (95-100ms) which is what we initialize the stack to...
I write the code without BLE part first, all the function works good but after I add the BLE part, it cause the chip reset. it seems like a random reset. why?
Hello, we would like to release our product to the market.
Our device is a (BLE) beacon based on nrf52 which is advertising some data encoded as manufacturing specific...
Hi everyone!
I have probelem with receice data over UART. In the other MCU use core ARM as : STM32, NXP... when a byte is recieved, MCU has flag to notify. That is "interrupt...
My code is in the link attached:
github.com/.../master
With that code we have a current measurement of 1.1mA. As you can see in the code, we have tried to disable all...
Hello guys, i am Dani.
Actually i am new in hardware communication and i have problem with BLE - Android Pairing.
The details are as follows:
I was trying to perform...
Hello,
As per my requirement I want to develop a device that would be capable of sending & receiving data to & from a web server & at any point of time multiple devices...
Hi everyone,
I am using board PCA10040 v1.1.0, softdevice 13.0.0, Eclipse Oxygen. I am trying to connect my board with a device call Daydream controller .
There is also...
