Debug Logger without softdevice, and the define ENABLE_DEBUG_LOG_SUPPORT to my project in the C/C++ tab.
i just test, very simple , but cannot get debug log..
int main...
I am trying to use the scheduler, but I would like to know if it is possible to have events with different priorities... As an example:
Task A - Priority LOW
Task B -...
FIXED (see below)
Hi!
I'm developing software for nRF52 on nRF52 preview DK, which I got on the Global Tech Tour.
LED blinking (blinky) example is running OK, so I moved...
Hello everyone,
I am using the great platformio toolchain that supports the mbed framework so far. I am still a newbie to it however.
I want to be able to use both the...
Hello!
I have a device with nRF51288. And I need to fill technical specification with the following parametres: operation freq., channel bandwidth, modulation, number of...
Hello,
Does anyone have a suggestion for a production programmer for the nRF24LE1 One Time Programmable version? I have been able to program the units with the nRFGo Studio...
Hello NRF ,
I have used NRF52832 with BLE advertise and peripherals connected on two different I2Cs ( temp sensor and gyro sensor ), One SPI( LCD Display ) , three GPIO...
I'm working with nRF52840 dongle, i installed nRF Connect for Desktop on windows but the led didn't start pulsing red. Has anyone else had an issue like this?
I am using SDK 16.0.0. I want to switch from a NON-CONNECTABLE, NON-SCANNABLE advertisement to a CONNECTABLE, SCANNABLE advertisement. I launch the first advertisement and...
Hello, I have a bit of a weird case. I'm sending data over Bluetooth. In the begging, I wrote whole data handling in the main.c main loop. everything worked nicely, so I have...
I'm developing uart program to communicate with arduino with nrf52840. And I'm working on s140 sdk.
First, I tried this code. It works, but first byte that send from arduino...
How can we get the timestamp using RTC(Real Time Clock). Do we need to add the external RTC for nordic thingy 52 board?
I am using the RSSI concept to calculate the distance...
Hello,
I have been trying to debug a curious behavior leading to higher energy consumption (~17mA) on my Sleepy End Device (Rx is off when idle).
I am using the nRF SDK...
I'm using nRF Connect v1.5.0 and Segger Embedded Studio (SES) to develop an application I'm testing on nRF5340-DK.
I want to create a "repeater" that has at least one...
When I use "Go" under debug, I get errors saying "No bootloader was found" and "ERROR 4 [NRF_ERROR_NO_MEM]".
However, when the same exact code is run on my friend's laptop...
Hi Nordic team,
I am having issues to connect to my Nordic device. The connection times out. By doing some research on the dev zone, it seems a known issue that could...
What is the fastest I can update information from the sensor to the nRF Cloud in terms of information every so many seconds?
This in reference to the asset_tracker file...
i have a custom NRF52832 board.
it have a 32mHz crystal but have not 32kHz crystal.
i use keil Uvision for programming, compile and burn the chip.
i use this example...
