Our USB keyboard using nrf24lu1p does not work on Mac OS 10.11.
Before Mac OS 10.11, USB keyboard was worked, but on Mac OS 10.11, it does not work.
I think your library...
In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
Hello,
I would like to have more info about canceling the pairing request on iPhone (thru the popup that asks if you want to pair with the device which is managed by iOS...
Hello everyone, I'm severely struggling to perform a simple task. I must be missing a very simple answer and, I hope with your help that I resolve the issue.
I am trying...
My 52833DK is apparently bricked. I get the message "Could not find core in Coresight setup. Abort debug session” When I try to load code (IAR) into the board. It was working...
Hi
I'm trying to understand the files outside the main program. The files that are at the samples path. Like "CMakeLists.txt, Kconfig, proj.conf, sample.yaml etc". So from...
Hello.
I have a issue about saadc input range.
First, using 52832, SDK 15.3.0 S332 Softdevice.
I using ble ant both and 2 rtc time and gpiote also used.
my goal is...
Hi guys!
Testing a little bit with the nRF511822 and Power Kit. After a little testing, I changed my application a bit and wanted to flash it into DK (via Keil) and it...
I have a requirement wherein I use the nordic chip to transmit the beacon data , after beaconing I want the beacon to go to a listen state and accept the data from a linux...
Hi,
We see that in documentation V1.1 there is this info on a pin added.
"AUX - Single-ended 50 Ω ANT loop-back pin"
What is the function of this pin?
Documentation...
I found several threads with same questions. And also found source codes.
But they are too old and require Legacy support for KEIL and old softdevice.
Is there actual source...
Hi,
The product is peripheral, CPU is nRF52832 and I use nRF5_SDK_15.2.0_9412b96.
My customer asks me how many bonded amounts support in our product?
because I can't...
If I enable the zephyr shell inside my project with the following config; I'm not able to see anything on the UART If I have CONFIG_SERIAL=y in the SPM prj.conf, If i disable...
hello:
I am using ble_central\ble_app_blinky_c example and attempt to be a central scanner to scan and connect to many BLE peripheral nodes.
The name of target BLE peripheral...
Hello.
We are running an application without BLE at this stage. We measure about 20ma at run time also by the datasheet max is 6ma.
We were thinking that because we don...
Hello All,
I purchased nrf9160 DK board for sending text message using AT Commands. I programmed the SIP to accept AT Commands. Using the LTE monitor app, I tried to initialize...
