But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Just ordered 2 Thingy52 and could only connect to one of them. Both boxes mention 1.1.0 2019.34
I used the code from https://github.com/NordicPlayground/Nordic-Thingy52...
I change the BLE SDK temelate example using this www.novelbits.io/.../ . In this I added 1 Custom service and 2 charactersitc. After compiling and running this got below logs...
I'm looking at implementing frequency hopping between multiple agents (fully connected swarm) in reasonably close proximity to each other (max distance about 150m in an open...
I am using ellisys sniffer and during tests found that the advertisements are getting missed on some of the channels(1 in 50 times).
For e.g. we can see advertisement only...
Hello,
I contact to you because a customer us interested on the part number #nRF52811, and they made the following questions, forwarded from our customer service representative;...
I have develop logic for connect particular device from a list of devices. Now I need logic for disconnect for particular device which I have connected.
Hi,
Could I enable SDH/SDH_SOC/SDH_BLE among bootloader (such as open_Bootloader_usb_mbr)?
Here I am customising my own bootloader upon open_Bootloader_usb_mbr in Nodic...
Hello.
In according to screen below, how to generate public key X and Y (with no OBB autentication)?
Should I create a method for generating these values?
I found...
I have the following code which generates a random number from 1 to 255 but I would like to add a range to the formula to be able to generate a number example starting form...
do you have any examples for disconnection based on BLE_HCI_REMOTE_USER_TERMINATED_CONNECTION BLE_HCI_LOCAL_HOST_TERMINATED_CONNECTION user defined disconnection.
Hi all:
So I'm going straight to the point, I have a board with NRF51822 that I dump the flash and programmed with another one, after that I notice that the firmware I...
I recently purchased the nRF5340 PDK. I am working through the getting started guide and can't seem to get the Heart Rate Monitor demo application working.
Firstly, when...
