Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
When I connected the development board with komoot (based on Android), komoot repeatedly disconnected again. The chip platform is nRF52832, and the protocol stack version...
Hi,
I try to rotate an image (180) with nrf_gfx_rotation_set(p_lcd, NRF_LCD_ROTATE_180). This only works once, but after, I want to return to the original position by re...
Hello
I am currently trying to get sensor values via SPI communication with mpu9250, a 9-axis sensor.
Although the following settings were made,acceleration,gyro,and...
Hi Sir,
I am going to the same phenomenon as below.
https://devzone.nordicsemi.com/f/nordic-q-a/45554/sdk-15-2-how-to-set-a-value-to-a-hid-feature-report
Can someone...
Eventually we got it working with the Master Control Panel again, but it will not work with our test software. I suspect a Window update change that affected links. Window7...
Hello,
I would like to implement a design using both the ESP32 Wi-Fi as well as the nRF52840 on the same PCB. As they both operate on the same 2.4GHz frequency and the antennas...
Hi,
I have used "write_handler(p_ble_evt->evt.gap_evt.conn_handle, p_rtc_service, p_evt_write->data[0]);" to send data to nrf52832 from mobile but iam able to send 1 byte...
Hello, I have 2 custom service running each with one characteristic. When data is written to the characteristic one (io_controle.c) the write event is triggered twice. The...
Hi,
did anybody find a suitable and cheap enclosure for the nRF51 Dongle? I want to use some of the dongles for initial tests before producing my own boards.
Thanks...
Hello, I have modified the example from the light switch on the mesh SDK and I can send and receive string messages, but the problem is that it doesn't work as expected, because...
I (unfortunately) had to make my own forks of Zephyr and NRF to get around a build issue, and decided to implement a west.yml manifest in my application repository. I made...
A makefile project using SDK 15.0.0 that compiled under GCC 7.2.1 no longer compiles under 7.3.1 with these errors:
../../../../../../external/segger_rtt/SEGGER_RTT_Syscalls_GCC...
Hi
I am trying to run the light_switch example, following the steps provided in this link . I have one Development board and 2 custom boards. It asks for Segger IDs for...
Section '5.2.1.1 Sleep' of the nRF9160 Production Specification v1.0 identifies SLEEP power with no RAM retention. My application will require partial RAM retention during...
