Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
Hii all
I am trying to run bootloader_signing example from the gcc. Nordic already gave an example for Keil I wanted to port the same thing for gcc. But its not working,...
Hi
I'd like to know three type of ESD models breakdown voltage lower limit.
・Machine model(MM)
・Human body model(HBM)
・Charged device model(CDM)
If nobody have the...
Hello,
i am working with the nRF52 DK and the SDK11. My intention is to receive arbitrary bytes via UART in non-blocking mode.
I have already read the following entry...
Hi I need use s130 softdevice as a central. So i am getting error with my existing code that works fine with s120 softdevice as central.
nordic_sdk_10/components/softdevice...
Hi, Nordic:
I'm testing the DC/DC function as to reduce the radio current. I have done the DC/DC test using pca10028 DK with the code below (SD v2.0.1, SDK11) :
void...
Hi,
I want to develop an ANT+BLE application using the D52Q module. I found the BLE serialization documentation but it's referred to S130, S132 SoftDevices. Is it compatible...
I have recently started getting the following error during a DFU using MCP.
Capture.PNG
Any idea as to the cause of this? What is the best way to debug this?
I am...
Hi,
I am wondering why PSTORAGE_NUM_OF_PAGES is by default set to 2 in the DFU project.
From what I understand the pstorage_raw.c module is used to update bootloader...
In iOS, it is possible for different apps to send data to the same characteristics in the same device by calling retrieveConnectedPeriphrals… Is there a way to identify the...
Hello,
currently, I am trying to get the SPI (master with EasyDMA) to work. I interfaced it with an LED driver IC , which needs some signaling (via GPIO pins) along with...
Hi,
I'm using the nrf52 board with sdk11.
I want to know that i have 100 beacons and my nrf52 is a cenral.
1)How many beacons can scan by the central at a time?
2...
Hi, I have managed to get my nrf51822 DK kit to read LDR sensor values. However the characteristic values are represented as hex on the master control panel and also on the...
Hi,
I'm i'm sniffing the NRF51822 s110, using the Nordic's BLE sniffer (on s120).
The BLE device is in a connection, and do a connection parameter update to a new interval...
