Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
I am using Segger for Mac. I followed the tutorial on importing a Nordic example from the Nordic SDK 12.0 examples folder. It is the UART BLE Peripheral Example.
I got...
Hi all, I'm working on secure bootloader SDk12, I made the required changes to work button less dfu now it jumping from application to bootloader but it needs write 0x01 manually...
The program is hanged when I use below code to set Manufacturing specific data (I am using SDK12.0.0 S130) Please comments.
uint16_t DataSize = 14;
uint8_t MfgSpecData...
Hello,
I would like to implement a precise timer which calculates/counts the time in microseconds which I can use for
calculating the time elapsed between parts of the...
Hi!
Does anyone run UARTE with EasyDMA enabled? I don't want to use interrupts and simply copy every received UARTE bytes to global tx_buffer....and pooling with amount...
Hi,
I want to produce a shared secret key between a Smartphone and a NRF52 in order to encrypt data later with AES-128 (example of key sharing: here ).
To do that i need...
Been having a bit of trouble porting our nRF51 project to nRF52 SDK11. It seems to not like using hal_cm4.c from RTX_CM4.lib with FPU. Seems to get stuck on OS_Tick_Handler...
HI，I want to store some data in 51822. These data was store by my program. I know the pstorage.c could store data. When I do DUF the data could be erased by the bootloader...
I am interested in optimising inputs for ADC measurement on an nRF52.
I have seen quite a bit about nRF51 but am unsure if this remains relevant for nRF52?
Hi!
I have an nRF52832 on a custom board. I managed to flash it through JLink and STLinkv2. But suddenly, I wasn't able to communicate to it anymore.
Openocd tells me...
Hi
The new signed DFU in the SDK12.1 comes along with a experimental buttonless DFU. There are a few bugfixes required to make it working, but the nRF Toolbox app didn...
Hi:
Recently, I want to use nRF52 to read or write some data from a flash chip(w25q128bv) by using spi, I've read Manufactures ID correctly, also, I have wrote a register...
Hello!
I need to interact with two J-Link debuggers, connected to the same PC at the same time. I would then read and write data to the devices connected to the debuggers...
Hi team,
iam using sdk 12.1.0 (ble_app_beacon) I want to advertise the battery percentage.Right now iam using the nrf dongle(it doesn't have cell coin battery) and flashing...
