Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
What is the max amount of data that can be saved in records in fds?
When we do a dfu, is the data conserved or not?
How to vary the size of the records if possible?
...
Hi all,
Recently, I have concentrated on a mesh project using nrf52840 board programmed sdk_mesh_v_3.1.0. There is a situation that the board needs to send two different...
We have a project to explain the company Shenzhen Zhouhai Technology Co. to invite them as our partner because we see the smart bracelet CK series would be a good option for...
Hello,
We're using the UDP/IP/6LoWPAN layers as provided by the nRF5 SDK 15.0.0.0.
After experiencing sporadic issues in communication we have a question regarding the...
Hi,
I am using BLE_Blinky_Peripheral example from SDK 15.3.0 with s112 softdevice. I want to use basic softdevice APIs instead of nrf_sdh libraries for enabling BLE stack...
I am a beginner trying to get a device to operate optimally under a battery. Where can I find a starter code template that would shutdown/disable everything, putting the device...
Hi there,
I am working with the NRF52840 Dongle and have been trying to verify what sort of influence other processes on the chip could have on the radio. Specifically,...
Hello Nordic team,
I'm having some trouble with discovering the characteristics of a custom device.
The peripheral device has a private service with UUID 06000002-0000...
I'm busy implementing a (serial) DFU host, but sofar i'm unable to send a proper init packet.
The bootloader keeps returning an invalid signature error
If i open a .dat...
I am using nrf52840dk
sdk15.3.0 and s140
I want to read a sensor data over uart and then advertise it but the advertising never starts after reading over uart even though...
IDE: Segger Embedded Studio
SDK: 15.2
Mesh SDK: 3.1.0
Im working on adding light lightness model to the mesh SDK and it requires doing an equation like sqrt(x * 65535...
Hi all,
I am working on a ble_app_uart sdk example thereby I can connect the bluetooth of nRf52840 to My mobile. I want to read the temperature and send it to my Mobile...
Hi, I am attempting to set up a nRF52840 DK as a BLE peripheral, and have been following the basic setup instructions at infocenter.nordicsemi.com/index.jsp . However, when...
Hallo everybody,
I successfully implemented on the NUS example the Pairing with the Passkey with the following Peer Manager configuration without LESC.
and the BLE...
I've written a DFU client in python. I'm trying to add the ability to restart a failed DFU without having to resend the whole file. I can see that the init packet is saved...
