Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
Now, we are checking nRF51822 ADC sample program in SDK.
When P0.1 input is lower than 0.7V, outputs is 0.
We are wondering if the performance is correct.
Could you...
I've been going back and forth with my manager, and I need source to show whether I'm right or wrong about a specific possible functionality of the nRF51.
I was wondering...
Hi, I have a Nordic nRF52 Development Kit. The ADC examples work, the LED examples work, and the NFC examples work. However, none of the Bluetooth examples work. The LEDs...
My DevKit arrived today. Very nice.
Plugged it into my mac, immediately recognized as USB device. Flashing LED, mounted as storage device, etc.
Tried to enter Bootloader...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
Hello everyone
I am trying to configure the write values like in the link loss profile it is possible to write no alert, mild alert, high alert, similarly i have created...
Hello!
I would like to know if it is possible to send an unique Gatt message that contains notification enable for multiple characteristics.
For example,
buf[0] ...
Hi Nordic,
I posted the issue with BSP package in devzone.nordicsemi.com/.../
unable to attach the main.c file mainOriginal.c
HI Aryan,
Thanks for your reply. Its working...
main.c HI Nordic,
I don't want bsp.c in my project. So I removed the bsp.c and included custom_board as mentioned in devzone.nordicsemi.com/.../
I am also using UART for...
I have the nRF52 dev board "PCA10040".
I downloaded "nRF52_SDK_0.9.1_3639cc9" SDK.
I noticed that there is no installer for the SDK.
I unzipped the SDK and using Keil...
