Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Using nRF51822, I define keys and pins as follows:
Keyboard key
Mouse left/right key
Mouse move (up/down/left/right)
Media play/pause key
Pin 0 Mouse...
Hi,
I am new to the nordic platform .I am using. BL652 modules .I was able to blink my on borad LED and then made the device as peripheral to advertise with the device name...
I'm using the nRF52832 with softdevice s132 and SDK14 with ARM GCC
I'm trying to set up the SAADC peripheral to read battery voltage, and I can get everything working as...
Hi all, We use a kind of widely used nrf24l01 module in our product developement.It use the nodic's reference design of nrf24l01 with an external pa/lna.TXEN and RXEN of the...
Hello! I have an Android phone and nRF52840 as a peripheral. Now I want the peripheral to have a whitelist with exactly 1 peer with whitelist being dropped at button press...
I read in many blogs that I can use access layer directly without models to communicate .
So access layer is under mesh?
means that can i send data to remote node(out...
Hello,
I have a NUS link between 2 nRF52840 (several systems like that) that I want to secure without human intervention (a kind of pre shared keys in code).
What is the...
Hello,
I a developing a system which consists of many BLE beacons over a given area and communicated between them forming a mesh. I would like to know whether nRF51822 can...
Hi
I want to struct ble multi link among several nrf52840
I merged ble_app_uart_c and ble_app_multilink_central but, It doesn't work.
The central is flashed with...
Hi,
I am trying to understand the design of the battery monitoring circuit of the Thingy52. I have few quiries:
1) The source resistor of the resistor divider network...
Probably, I am having a problem with finding the proper query phrase.
I have a sensor (Hall-type sensor) that generates pulses, and I need to count the total number of pulses...
Hello,
I am using
nordic nrf52 SDK version : v15.2.0
Freertos version : V10.0.1
The system has hardware timer which runs at 6.4KHz. For every 1.6 KHz, from timercallback...
Hi
AfterI updated the nrf_Connect v2.02 IOS version. I found that disconnect will happen when key in the bonding code "123456".
And my code never has this issus with previous...
Hello to all,
I am using nRF52840 DK with SDK15.0 and SES. To communicate with MS5540C I have used SPI master sample example but getting some incorrect results.
Almost...
I get a lot of error after just adding usbd source code into makefile. error: unknown type name 'NRF_USBD_Type', error: 'USBD_INTEN_ENDISOIN_Msk' undeclared here (not in a...
