Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hello.
I'm trying to implement my own RF protocol, with the help of reference manual and examples provided here I was able to come up with this: http://pastebin.com/t2nhkj2B...
Now with the twi_hw_master.c with softdevice, I enable the twi on the start of twi_master_transfer and disable it at the end of twi_master_transfer, but I found the twi can...
Hi All,
I am in need to implement the Central BLE device which can receive the Data from an iOS peripheral device over a particular custom characteristic, Can anyone please...
I'm trying to implement my own radio protocol but the section about addressing in reference manual is very unclear to me. In the "Definition of logical addresses" table it...
Is it possible to protect part of the memory of nRF24le1, in such a way, that it can be used for a serial number?
For my application, it would be beneficial to be able...
Hello,
In the example "nRF51_SDK_8.1.0_b6ed55fvery\examples\ble_central\ble_app_multilink_central\pca10028" when opened in keil there is no flash_softdevice option shown...
dear everyone!
I order a kit- nRF52 preview DK:
www.nordicsemi.com/.../nRF52-Preview-DK
And i also download nRF52_SDK_0.9.1_3639cc9.zip:
developer.nordicsemi.com...
Hello,
I'm writing a driver for an I2C device (it's an external led driver).
My current code executes following steps ...
First I changed I2C configuration :
static...
Hello there.
I'm porting some code that previously worked on S110 stack v7 to stack v8 and I'am experiencing some issues.
After receiving a BLE_EVT_USER_MEM_REQUEST...
Accoding to the "how to generate the INIT file for the DFU",I have configuration Boot loader.hex,but i don't known how to configuration Soft Device.hex.The following is the...
Hello Nordic~
I want to control button debouncing on my nrf51822 based custom board. I went through the button_debounce example found in [Board/nrf6310/debounce_example...
Hi All,
I'm using ble_app_uart Application to send some notifications from Peripheral to central device. I'm using API ble_send_string() to send notifications to other...
