Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hello everyone,
I have 2 chip; Bluegiga and nRF51-DK
I can easily advertise my custom service in Bluegiga chip. As you can see, nRF Connect application shows my service...
I think one way or the other the struct ble_gatts_evt_t must be correlated with the GATT profile, that is, ble_gatts_evt_t should have services and characteristics as its...
Hi,
> Context:
I run a baremetal application that I would like to enhance with bluetooth.
I am considering a BLE module from NS.
I currently have a SoC (nanopi...
I have created a nRF52 based peripheral device which is used to stream sensor data to a connected central device, usually an iPhone. I can stream data, reliably to the iPhone...
I have an odd situation. I've been using an iPhone 5 and 6 to connect to, and test against, both an nRF51 (redbear nano) and the same code built for nRF52. It works fine....
Hi All,
i am using nrf51822 with SDK 12 and i am not able to find where All BAUDRATE Macro is defined for APP_UART.
so anyone can tell about that in which file it is...
I looked at examples and added identical code to my own app, specifically to a) set the gatt_enable_params.att_mtu to GATT_MTU_SIZE_DEFAULT, and b) to handle BLE_GATTS_EVT_EXCHANGE_MTU_REQUEST...
Hi,
Is there an extensive documentation about programming process of a nrf52832 using keil?
I just spent hours figuring out that I had to use Softdevice erase flash algorithm...
I just followed "Testing the example manually (without bonding)" steps to manually update firmware by Master Control Panel.
But every time, I got log message, "SERVER:...
I am implementing mqtt client on Nrf52832 with the example provided in the IoT SDK. I am looking for the correct way to make the client to run with Non-Nordic socket stack...
I've just finished my first layout for nRF51822, and I need a help with the attenna design.
The RF part of the schematic and layout is a copy of your reference design, "PCA10004...
Hi
I'm using BLE400 board (from waveshare) which have a nrf51822 chip on it. When I want to program the softdevice with nrfgo I encounter the following error:
link text...
Hi, I got a problem.
I created a timer, interval is 30ms.
#define MIN_CONN_INTERVAL MSEC_TO_UNITS(150, UNIT_10_MS) /**< Minimum acceptable connection interval (0.02...
