Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hello,
I noticed the various examples as well as the ble_advertising component all check for pending flash operations and will not start advertising until they are all...
Hi,
I am busy writing my own softdevice, this has nothing to do with bleutooth or anything like this.
In the past i didn't have to worry about the CLENR0 register because...
Hi everybody,
I have a mistake with my makefile on windows 7 platform and Eclipse C edition.
The error is quite rapid =>
20:42:38 **** Build of configuration Default...
Hello devzone...
My setup: nRF51422 and S110 peripheral
My setup transmits IR data on reception of Bluetooth data from a central device. I have used PWM for generating IR...
Does the nRF51422 ANT Inclusion/Exclusion list require all values in the list to be defined, or may some of them be '0' or 'wildcard' values?
Asked in another way, does...
Hi every one,
First of all, i'd like to thank everyone for their support and assist
I try to use the internal ADC of nrf51822 module and send the value over bluetooth...
Hi,
Is there a sample which explains about how to store some user data or do some data logging on to flash of a central device.
I tried to do it, but since device manager...
I added a registration to the pstorage module of the multilink peripheral example. However, upon calling dm_init() I get error code 7, invalid param. I checked the documentation...
I recently bought a nrf51DK. It comes with 5 sample pieces of the nrf51422 IC.
My question would be how to program this since the IC on the dev kit is not changeable? Or...
I am trying to understand the operation between BLE device & android application...
After "CONNECT_REQ", I can see several "SERVICE PROFILES" but I can't find those UUID...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hi,
As I’ve mentioned in a previous post (answered ! Thank you Aryan !), I'm writing a bootloader for nrf51822 to be able to update the nRF51's firmware through SPI (data...
Dear community and support,
I am trying to install Master Control Panel 3.9.0.6-x86 on a Windows-XP virtualbox. The installer fails with the following message :
"The installer...
